Allied Telesis IE340 Series - Page 3061

C613-50631-01 Rev A Command Reference for IE340 Series 3061
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
DYNAMIC HOST CONFIGURATION PROTOCOL (DHCP) COMMANDS
IP
DHCP-RELAY AGENT-OPTION SUBSCRIBER-ID
Output Figure 58-2: Example output from show interface
Related
commands
show interface
Command
changes
Version 5.5.2-0.1: command added
awplus#show interface port1.0.1 
Interface port1.0.1 
Scope: both 
Link is DOWN, administrative state is UP 
Thrash-limiting 
Status Not Detected, Action learn-disable, Timeout 1(s) 
Hardware is Ethernet, address is e01a.ea60.087f 
index 5010 metric 1 mru 1500 
configured duplex auto, configured speed auto, configured polarity auto 
<UP,BROADCAST,MULTICAST>
SNMP link-status traps: Disabled 
DHCP subscriber-id substitution for client-id is not enabled 
DHCP subscriber-id is office-1 
input packets 0, bytes 0, dropped 0, multicast packets 0 
output packets 0, bytes 0, multicast packets 0, broadcast packets 0 
input average rate : 30 seconds 0 bps, 5 minutes 0 bps 
output average rate: 30 seconds 0 bps, 5 minutes 0 bps 
Time since last state change: 0 days 17:51:00