Allied Telesis IE340 Series - Page 3071

C613-50631-01 Rev A Command Reference for IE340 Series 3071
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
DYNAMIC HOST CONFIGURATION PROTOCOL (DHCP) COMMANDS
IP
DHCP USE-SUBSCRIBER-ID
Example 2 In Interface Configuration mode, to configure subscriber identifier substitution for
the client identifier on packets sent by a DHCP client directly attached to port
port1.0.1, use the commands:
awplus# configure terminal
awplus(config)# interface port1.0.1
awplus(config-if)# ip dhcp use-subscriber-id
Output Figure 58-5: Example output from show interface
Related
commands
show ip dhcp server summary
show interface
Command
changes
Version 5.5.2-0.1: command added
awplus#show interface port1.0.1
Interface port1.0.1
Scope: both
Link is DOWN, administrative state is UP
Thrash-limiting
Status Not Detected, Action learn-disable, Timeout 1(s) 
Hardware is Ethernet, address is e01a.ea60.087f 
index 5010 metric 1 mru 1500 
configured duplex auto, configured speed auto, configured
polarity auto

SNMP link-status traps: Disabled 
DHCP subscriber-id substitution for client-id is enabled 
DHCP subscriber-id is office-1 
input packets 0, bytes 0, dropped 0, multicast packets 0 
output packets 0, bytes 0, multicast packets 0, broadcast
packets 0 
input average rate : 30 seconds 0 bps, 5 minutes 0 bps 
output average rate: 30 seconds 0 bps, 5 minutes 0 bps 
Time since last state change: 0 days 17:51:00