Allied Telesis IE340 Series User Manual

C613-50631-01 Rev A Command Reference for IE340 Series 3099
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
DYNAMIC HOST CONFIGURATION PROTOCOL (DHCP) COMMANDS
SHOW
IP DHCP POOL
Output Figure 58-13: Example output from the show ip dhcp pool command with a host
with MAC 0000.cd38.05f9 is registered as a static host by DHCP
Framed IP Lease feature from AUTHD:
Pool p1 :
network: 10.1.1.0/24
address ranges:
addr: 10.1.1.101 to 10.1.1.199
(static host addr 10.1.1.122 excluded)
(static host addr 10.1.1.111 excluded)
static host addresses:
addr: 10.1.1.122 MAC addr: 0000.1111.2222
addr: 10.1.1.111 MAC addr: 0000.cd38.05f9
Netmask : 255.255.255.0
Gateway : 10.1.1.1
Lease : 60 seconds
Added by AUTHD
lease <1:0:0:0>
subnet mask: 255.255.255.0 (pool's network mask)
Probe: Default Values
Status: Enabled [Enabled]
Type: Ping [Ping]
Packets: 5 [5]
Timeout: 200 msecs [200]
Dynamic addresses:
Total: 97
Leased: 1 
Utilization: 1.0 %
Static host addresses:
Total: 2
Leased: 2
Table 3: Parameters in the output of the show ip dhcp pool command
Parameter Description
Pool Name of the pool.
network Subnet and mask length of the pool.
address ranges Individual IP addresses and address ranges
configured for the pool. The DHCP server can offer
clients an IP address from within the specified
ranges only.
Any of these addresses that match an interface
address on the device, or a static host address
configured in the pool, will be automatically
excluded from the range, and a message to this
effect will appear beneath the range entry.

Allied Telesis IE340 Series Specifications

General

Brand	Allied Telesis
Model	IE340 Series
Category	Switch
Language	English