C613-50631-01 Rev A Command Reference for IE340 Series 3195
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
SNMP COMMANDS
SNMP
-SERVER ENABLE TRAP
Default Disabled
Mode Global Configuration
Usage notes This command cannot be used to enable link status notifications globally. To
enable link status notifications for particular interfaces, use the snmp trap
link-status command.
To specify where notifications are sent, use the snmp-server host command.
Note that you can enable (or disable) multiple traps with a single command, by
specifying a space-separated list of traps.
Examples To enable the device to send a notification if an AMF node changes its status, use
the following commands:
awplus# configure terminal
awplus(config)# snmp-server enable trap atmfnode
To enable the device to send PoE related traps, use the following commands:
awplus# configure terminal
awplus(config)# snmp-server enable trap power-inline
To disable PoE traps being sent out by the device, use the following commands:
awplus# configure terminal
awplus(config)# no snmp-server enable trap power-inline
To enable the device to send MAC address Thrash Limiting traps, use the following
commands:
awplus# configure terminal
awplus(config)# snmp-server enable trap thrash-limit
nsm NSM traps.
ospf OSPF traps.
pim PIM traps.
power-inline Power-inline traps (Power Ethernet MIB RFC 3621).
qsp QoS Storm Protection.
rmon RMON traps.
thrash-limit MAC address Thrash Limiting traps.
vcs VCS traps.
vrrp Virtual Router Redundancy (VRRP) traps.
ufo Upstream Forwarding Only (UFO) traps.
Parameter Description
To Next Page
Loading...
Need help?
General
