Allied Telesis IE340 Series User Manual

C613-50631-01 Rev A Command Reference for IE340 Series 3209
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
SNMP COMMANDS
SNMP
-SERVER USER
•Use the encrypted parameter when you want to enter already encrypted
passwords in encrypted form as displayed in the running and startup configs
stored on the device. For example, you may need to move a user from one
group to another group and keep the same passwords for the user instead
of removing the user to apply new passwords.
• User passwords are entered using plaintext without the encrypted
parameter and are encrypted according to the authentication and privacy
protocols selected.
• User passwords are viewed as encrypted passwords in running and startup
configs shown from show running-config and show startup-config
commands respectively. Copy and paste encrypted passwords from
running-configs or startup-configs to avoid entry errors.
Examples To add SNMP user authuser as a member of group ‘usergroup’, with authentication
protocol MD5, authentication password ‘Authpass’, privacy protocol AES and
privacy password ‘Privpass’ use the following commands:
awplus# configure terminal
awplus(config)# snmp-server user authuser usergroup auth md5
Authpass priv aes Privpass
Validate the user is assigned to the group using the show snmp-server user
command:
To enter existing SNMP user ‘authuser’ with existing passwords as a member of
group ‘newusergroup’ with authentication protocol MD5 with the encrypted
authentication password 0x1c74b9c22118291b0ce0cd883f8dab6b74, and privacy
protocol AES with the encrypted privacy password
0x0e0133db5453ebd03822b004eeacb6608f, use the following commands:
awplus# configure terminal
awplus(config)# snmp-server user authuser newusergroup
encrypted auth md5 0x1c74b9c22118291b0ce0cd883f8dab6b74 priv
aes 0x0e0133db5453ebd03822b004eeacb6608f
NOTE: Copy and paste the encrypted passwords from the running-config or the
startup-config displayed, using the show running-config and show startup- config
commands respectively, into the command line to avoid key stroke errors issuing this
command.
Validate the user has been moved from the first group using the show
snmp-server user command:
awplus#show snmp-server user
Name Group name Auth Privacy
------- ------------- ------- ----------
authuser usergroup md5 aes

Allied Telesis IE340 Series Specifications

General

Brand	Allied Telesis
Model	IE340 Series
Category	Switch
Language	English