Allied Telesis IE340 Series User Manual

C613-50631-01 Rev A Command Reference for IE340 Series 388
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
CONNECTIVITY FAULT MANAGEMENT COMMANDS
SHOW
ETHERNET CFM ERRORLOG
Related
commands
clear ethernet cfm errorlog
ethernet cfm domain-name
ethernet cfm mep
mep crosscheck
service ma-name
Command
changes
Version 5.4.7-1.1: command added
Version 5.4.8-0.2: added to SBx8100 series products
Version 5.4.8-1.1: added to SBx908 GEN2 series products
Error Reason One of the following:
“Remote MEP Down” - an RMEPCCMDefect has been
declared for this remote MEP. CCMs have not been
received from this remote MEP within the CCM interval.

“MEP Configuration” - the CCM received from the remote
MEP has the same MEP ID as the local MEP that received
the CCM. For unicast remote MEPs this error can also
indicate that even though the CCM received from the
remote MEP has an MEP ID that matches a configured
remote MEP ID in the MA, the source MAC address differs
from the configured MAC address for that remote MEP.

“Forwarding Loop” - the CCM received from the remote
MEP has an MEP ID that matches a configured local MEP ID
in the MA, and also has the same source MAC address as
the local MEP's MAC address that received the CCM.

“Cross Connected” - a xconCCMdefect was detected.
CFM Service Name The name of the MA associated with the MD for this
error(s).
Table 9-3: Parameters in the output from show ethernet cfm errorlog domain
MD-INST2 (cont.)
Parameter Description

Allied Telesis IE340 Series Specifications

General

Brand	Allied Telesis
Model	IE340 Series
Category	Switch
Language	English