Allied Telesis IE340 Series User Manual

C613-50631-01 Rev A Command Reference for IE340 Series 397
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
CONNECTIVITY FAULT MANAGEMENT COMMANDS
SHOW
ETHERNET CFM MAINTENANCE-POINTS REMOTE MEP
Related
commands
ethernet cfm domain-name
mep crosscheck
service ma-name
show ethernet cfm details
Command
changes
Version 5.4.7-1.1: command added
Version 5.4.8-0.2: added to SBx8100 series products
Version 5.4.8-1.1: added to SBx908 GEN2 series products
Table 9-6: Parameters in the output from show ethernet cfm
maintenance-points remote mep
Parameter Description
CFM Domain Name
and CFM Service
Name
The instance identifiers that uniquely identify the MA and
MD for the remote MEP(s) of interest.
Remote MEPID The remote MEP ID that is configured for this MA.
Receiving CCMs The current state of the 802.1ag remote MEP state
machine:
Yes - RMEP_OK. CCMs are being received without any
error.
Wait - RMEP_START. Still preparing to receive remote MEP
CCMs without a timeout occurring.
Failed - RMEP_FAILED. While waiting to receive CCMs from
a remote MEP, a timeout occurred.
- - the state machine is not running.
RX RDI The current RDI being received from this remote MEP:
True - the last CCM received from the remote MEP has the
RDI set. This means the remote MEP itself is seeing one of
the following defects: someRMEPCCMDefect,
someMACstatusDefect, errorCCMdefect, xconCCMdefect.
False - the last CCM received from the remote MEP does
not have its RDI set.
MAC Address The configured or discovered MAC address of the remote
MEP.
Port Status If the CCM was received with a port status TLV, this
indicates the last value received, or "-" if none received.
Interface Status If the CCM was received with an interface status TLV, this
indicates the last value received, or "-" if none received.

Allied Telesis IE340 Series Specifications

General

Brand	Allied Telesis
Model	IE340 Series
Category	Switch
Language	English