C613-50631-01 Rev A Command Reference for IE340 Series 514
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
INTERFACE COMMANDS
SHOW
INTERFACE STATUS
Related
commands
show interface
show interface brief
show interface memory
Table 15: Parameters in the output from the show interface status command
Parameter Description
Port Name/Type of the interface.
Name Description of the interface.
Status The administrative and operational status of the interface; one of:
• disabled: the interface is administratively down.
• connect: the interface is operationally up.
• notconnect: the interface is operationally down.
Vlan VLAN type or VLAN IDs associated with the port:
• When the VLAN mode is trunk, it displays trunk (it does not
display the VLAN IDs).
• When the VLAN mode is access, it displays the VLAN ID.
• When the VLAN mode is private promiscuous, it displays the
primary VLAN ID if it has one, and promiscuous if it does not
have a VLAN ID.
• When the VLAN mode is private host, it displays the primary
and secondary VLAN IDs.
• When the VLAN is dynamically assigned, it displays the current
dynamically assigned VLAN ID (not the access VLAN ID), or
dynamic if it has multiple VLANs dynamically assigned.
Duplex The actual duplex mode of the interface, preceded by a- if it has
autonegotiated this duplex mode. If the port is disabled or not
connected, it displays the configured duplex setting.
Speed The actual link speed of the interface, preceded by a- if it has
autonegotiated this speed. If the port is disabled or not
connected, it displays the configured speed setting.
Type The type of interface, e.g. 1000BaseTX. For SFP bays, it displays
Unknown if it does not recognize the type of SFP installed, or Not
present if an SFP is not installed or is faulty.
To Next Page
Loading...
Need help?
General
