C613-50631-01 Rev A Command Reference for IE340 Series 579
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
SWITCHING COMMANDS
LOOP
-PROTECTION LOOP-DETECT
to be transmitted by the device each second (the Total Instances entry). It also
shows the number of packets that timed out for each port (the Timeout entry). The
show loop-protection counter command shows the number of timeouts per
VLAN for each port.
See the “Loop Protection” section in the Switching Feature Overview and
Configuration Guide for more relevant conceptual, configuration, and overview
information before applying this command.
Example To enable the loop-detect mechanism on the switch, and generate loop-detect
frames once every 5 seconds, use the following commands:
awplus# configure terminal
awplus(config)# loop-protection loop-detect ldf-interval 5
Related
commands
loop-protection action
loop-protection timeout
show loop-protection
To Next Page
Loading...
Need help?
General
