Allied Telesis IE340 Series - Page 603

C613-50631-01 Rev A Command Reference for IE340 Series 603
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
SWITCHING COMMANDS
SHOW
LOOP-PROTECTION
Output Figure 15-4: Example output from the show loop-protection command:
Example To display the counter information, use the command:
awplus# show loop-protection counters
Output Figure 15-5: Example output from the show loop-protection counters
command:
Related
commands
clear loop-protection counters
loop-protection action
loop-protection loop-detect
awplus#show loop-protection

LDF Interval: 10
Fast Block: Disabled
Total Instances: 29174 (2917 packets/s)
Timeout
Int Enabled Action Status Timeout Remain Rx port
--------------------------------------------------------------------------
port1.0.1 Yes vlan-dis Normal 7 - -
port1.0.2 Yes vlan-dis Normal 0 - -
port1.0.3 Yes vlan-dis Normal 0 - -
...
awplus#show loop-protection counters

Switch Loop Detection Counter

Interface Tx Rx Tx Timeout Rx Invalid Last LDF Rx
-------------------------------------------------------------------------
port1.0.1
vlan1 60 0 7 0 -
port1.0.2
vlan1 0 0 0 0 -
port1.0.3
vlan1 0 0 0 0 -
...