Allied Telesis IE340 Series - Page 762

C613-50631-01 Rev A Command Reference for IE340 Series 762
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
SPANNING TREE COMMANDS
SPANNING
-TREE PORTFAST BPDU-GUARD
Use the show spanning-tree command to display the device and port
configurations for the BPDU Guard feature. It shows both the administratively
configured and currently running values of bpdu-guard.
Example To enable STP BPDU guard in Global Configuration mode, enter the below
commands:
awplus# configure terminal
awplus(config)# spanning-tree portfast bpdu-guard
To enable STP BPDU guard in Interface Configuration mode, enter the below
commands:
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# spanning-tree portfast bpdu-guard enable
Related
commands
spanning-tree edgeport (RSTP and MSTP)
show spanning-tree
spanning-tree portfast (STP)
spanning-tree portfast bpdu-filter