Allied Telesis IE340 Series User Manual

C613-50631-01 Rev A Command Reference for IE340 Series 833
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
POWER OVER ETHERNET COMMANDS
SHOW
POWER-INLINE INTERFACE
Table 3: Parameters in show power-inline interface output
Parameter Description
Interface The PoE port(s) in the format port1.0.z, where z is the port
number.
After the port number, “/D” indicates the data pair and “/S”
indicates the spare pair (for ports that support high-power PoE).
Admin The administrative state of PoE on a PoE port, either Enabled or
Disabled.
Pri The current PoE priorities for PoE ports on the PSE, as configured
from a power-inline priority command:
• Low displays when the low parameter is issued. The lowest
priority for a PoE enabled port (default).
• High displays when the high parameter is issued. The
second highest priority for a PoE enabled port.
• Crit displays when the critical parameter is issued. The
highest priority for a PoE enabled port.
Oper The current PoE port state when this command was issued:
• Powered displays if there is a PD connected and power is
being supplied.
• Denied displays if supplying power would make the switch
go over the power budget. It also displays if the switch is
overheating and therefore has stopped supplying power to
the port.
• Off displays if the port is not supplying power but has not
been denied power by the switch. This is the default state for
ports that are not connected to a PD.
• Disabled displays if the PoE port is administratively disabled.
• Syncing displays if PoE is still initializing the port when you
issue the command.
• Fault displays if there is a problem with PoE on the port.
• Unknown displays if PoE cannot determine the state of the
port.
Power The power consumption in milliwatts (mW) for the PoE port
when this command was entered.
Device The description of the connected PD device if a description has
been added with the power-inline description command. No
description is shown for PDs not configured with the
power-inline description command.
Class The class of the connected PD, if power is being supplied to the
PD from the PSE.
See the PoE Feature Overview and Configuration Guide for
further information about power classes.

Allied Telesis IE340 Series Specifications

General

Brand	Allied Telesis
Model	IE340 Series
Category	Switch
Language	English