C613-50631-01 Rev A Command Reference for IE340 Series 349
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
PLUGGABLES AND CABLING COMMANDS
SHOW
SYSTEM PLUGGABLE DETAIL
Related
commands
show system environment
show system pluggable
show system pluggable diagnostics
Device Type Specifies the device type for the installed pluggable
transceiver.
Serial Number Specifies the serial number for the installed pluggable
transceiver.
Manufacturing
Datecode
Specifies the manufacturing datecode for the installed
pluggable transceiver. Checking the manufacturing
datecode with the vendor may be useful when
determining Laser Diode aging issues. For more
information, see “Troubleshooting Fiber and Pluggable
Issues” in the "Pluggables and Cabling" Feature Overview
and Configuration Guide.
SFP Laser
Wavelength
Specifies the laser wavelength of the installed pluggable
transceiver.
Single Mode Fiber Specifies the link length supported by the pluggable
transceiver using single mode fiber.
OM1 (62.5um)
Fiber
Specifies the link length (in ÎĽm - micron) supported by the
pluggable transceiver using 62.5 micron multi-mode fiber.
OM2 (50um) Fiber Specifies the link length (in ÎĽm - micron) supported by the
pluggable transceiver using 50 micron multi-mode fiber.
Diagnostic
Calibration
Specifies whether the pluggable transceiver supports DDM
or DOM Internal or External Calibration:
Internal is displayed if the pluggable transceiver supports
DDM or DOM Internal Calibration.
External is displayed if the pluggable transceiver supports
DDM or DOM External Calibration.
- is displayed if neither Internal Calibration or External
Calibration is supported.
Power Monitoring Displays the received power measurement type, which can
be either OMA (Optical Module Amplitude) or Avg
(Average Power) measured in ÎĽW.
Table 8-1: Parameters in the output from show system pluggable detail (cont.)
Parameter Description
To Next Page
Loading...
Need help?
General
