Allied Telesis IE340 Series User Manual

C613-50631-01 Rev A Command Reference for IE340 Series 392
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
CONNECTIVITY FAULT MANAGEMENT COMMANDS
SHOW
ETHERNET CFM MAINTENANCE-POINTS LOCAL MEP
CC State The MEP's CCM configured administrative state:
Up: Enable
Down: Disable.
CC Type The configured CCM sending and receiving type, either
multicast or unicast. If not yet configured, it shows as
None.
Tx-RDI Whether this local MEP is sending RDI or not. An RDI is
sent when one or more of the following defects have been
declared by the local MEP:
someRMEPCCMdefect
someMACstatusDefect
errorCCMdefect
xconCCMdefect
Current Defects A list of defects the local MEP is currently detecting. It
shows the defect(s), as both a defect priority and name.
Current Highest
Defect Alarm
The highest defect priority that has been encountered
while the local MEP has been in an alarm state.
Alarm Minimum
Defect
The minimum defect the local MEP has to see before
declaring an alarm.
Alarm Trip Time The amount of time the defect has to exist before an alarm
is declared.
Configured Remote
MEP IDs
A comma separated list of configured remote MEPs (by
MEP IDs) known by this local MEP. If the remote MEP also
has a configured unicast MAC address, the MEP ID will also
include -HHHH.HHHH.HHHH.
Missing Remote
MEPs
The remote MEPs (by MEP ID) that have been configured
against this local MEP but have not been heard from.
Table 9-5: Parameters in the output from show ethernet cfm
maintenance-points local mep domain <domain-name> service
<ma-name> mep <mep-id> details (cont.)
Parameter Description

Allied Telesis IE340 Series Specifications

General

Brand	Allied Telesis
Model	IE340 Series
Category	Switch
Language	English