Siemens SINAMICS S Series - p9910 Transfer additional components into the target topology; Transfer comp; p9915 DRIVE-CLiQ data transfer error shutdown threshold master; DLQ fault master; p9916 DRIVE-CLiQ data transfer error shutdown threshold slave; DLQ fault slave; p9920[0...19] Licensing, enter license key; Enter license key

Parameters
List of parameters
1-1044
© Siemens AG 2007 All Rights Reserved
SINAMICS S List Manual (LH1), 07/2007
For p9909 = 0, serial numbers and hardware versions are not automatically transferred. In this case, the transfer
must be made using p9904.
Dependency: Refer to: p9904, p9905
Note: The modified target topology is automatically saved in a non-volatile fashion when the drive object runs-up (e.g.
after a POWER ON).
Special case for Control Unit and option slot modules:
When replacing these components, independent of p9909, the serial number and hardware version are automati-
cally transferred and saved in a non-volatile fashion.
Description: Transfer additional inserted DRIVE-CLiQ components into the target topology and add the appropriate drive objects
to the project.
Values: 0: No selection
1: Drive object type SERVO
2: Drive object type VECTOR
3: SINAMICS GM (DFEMV & VECTORMV)
4: SINAMICS SM (AFEMV & VECTORMV)
5: SINAMICS GL (VECTORGL)
Description: Only for internal Siemens service.
Description: Only for internal Siemens service.
Description: Enters the license key for this drive unit.
Example of the license key:
EACZ-QBCA = 69 65 67 90 45 81 66 67 65 dec (ASCII characters)
p9910 Transfer additional components into the target topology / Transfer comp
CU_CX32, CU_S Can be changed: C1(1) Calculated: - Access level: 1
Data type: Integer16 Dynamic index: - Func. diagram: -
P-Group: Topology Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
0 5 0
p9915 DRIVE-CLiQ data transfer error shutdown threshold master / DLQ fault master
CU_CX32, CU_S Can be changed: C1(1) Calculated: - Access level: 4
Data type: Unsigned32 Dynamic index: - Func. diagram: -
P-Group: Topology Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
0000 hex 0007 07FF hex 0007 02FF hex
p9916 DRIVE-CLiQ data transfer error shutdown threshold slave / DLQ fault slave
CU_CX32, CU_S Can be changed: C1(1) Calculated: - Access level: 4
Data type: Unsigned32 Dynamic index: - Func. diagram: -
P-Group: Topology Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
0000 hex 0007 07FF hex 0007 02FF hex
p9920[0...19] Licensing, enter license key / Enter license key
CU_S Can be changed: U, T Calculated: - Access level: 2
Data type: Unsigned8 Dynamic index: - Func. diagram: -
P-Group: - Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - -