Siemens SINAMICS S Series - r1214.0...15 CO;BO: Automatic restart, status; AR status

To Next Page

To Previous Page

List of parameters

Parameters

1-341

SINAMICS S List Manual (LH1), 07/2007

Note: Re bit 00:

Status to display the single initialization after POWER ON.

Re bit 01:

State in which the automatic restart function waits for faults (initial state).

Re bit 02:

General display that a fault has been identified and that the restart or acknowledgement has been initiated.

Re bit 03:

Displays the acknowledge command within the "acknowledge alarms" status (bit 4 = 1). For bit 5 = bit 6 = 1, the

acknowledge command is continually displayed.

Re bit 04:

State in which the faults that are present are acknowledged. The status is exited again after successful acknowl-

edgement. A change is only made into the next state if it is signaled that a fault is no longer present after an

acknowledgement command (bit 3 = 1).

Re bit 05:

State in which the drive is automatically powered-up (only for p1210 = 4, 6).

Re bit 06:

State in which the system waits after having been powered-up, to the end of the start attempt.

For p1210 = 1, this signal is directly set after the faults have been successfully acknowledged.

Re bit 07:

State, which is assumed after a fault occurs within the automatic restart function.

Re bits 12 ... 15:

Actual state of the start counter (binary coded).

Description: Automatic restart (AR) status word.

Bit field: Bit Signal name 1 signal 0 signal FP

00 Initialization Yes No -

01 Wait for alarm Yes No -

02 Auto restart active Yes No -

03 Setting the acknowledgement command Yes No -

04 Acknowledge alarms Yes No -

05 Restart Yes No -

06 Delay time running after automatic power-

Yes No -

07 Fault Yes No -

12 Start count. bit 0 On Off -

13 Start count. bit 1 On Off -

14 Start count. bit 2 On Off -

15 Start count. bit 3 On Off -

r1214.0...15 CO/BO: Automatic restart, status / AR status

SERVO, VECTOR Can be changed: - Calculated: - Access level: 3

Data type: Unsigned16 Dynamic index: - Func. diagram: -

P-Group: Functions Units group: - Unit selection: -

Not for motor type: - Expert list: 1

Min Max Factory setting

- - -