List of parameters
Parameters
1-499
© Siemens AG 2007 All Rights Reserved
SINAMICS S List Manual (LH1), 07/2007
Description: Displays the nominal stator inductance identified for the 4th point of the saturation characteristic.
Index: [0] = Phase U
[1] = Phase V
[2] = Phase W
Description: Displays the identified dynamic total leakage inductance.
Index: [0] = Phase U
[1] = Phase V
[2] = Phase W
Index: [0] = Phase U
[1] = Phase V
[2] = Phase W
Index: [0] = Phase U
[1] = Phase V
[2] = Phase W
r1919[0...2] Identified stator inductance 4 / L_stator 4 ident
VECTOR Can be changed: - Calculated: - Access level: 4
Data type: Floating Point Dynamic index: - Func. diagram: -
P-Group: Motor identification Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- [mH] - [mH] - [mH]
r1920[0...2] Identified dynamic leakage inductance / L_leak dyn ident
VECTOR Can be changed: - Calculated: - Access level: 4
Data type: Floating Point Dynamic index: - Func. diagram: -
P-Group: Motor identification Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- [mH] - [mH] - [mH]
r1921[0...2] Identified dynamic leakage inductance 1 / L_leak 1 dyn id
VECTOR Can be changed: - Calculated: - Access level: 4
Data type: Floating Point Dynamic index: - Func. diagram: -
P-Group: Motor identification Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- [mH] - [mH] - [mH]
r1922[0...2] Identified dynamic leakage inductance 2 / L_leak 2 dyn id
VECTOR Can be changed: - Calculated: - Access level: 4
Data type: Floating Point Dynamic index: - Func. diagram: -
P-Group: Motor identification Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- [mH] - [mH] - [mH]
To Next Page
Loading...
