Siemens SINAMICS S Series - p0820[0...n] BI: Drive data set selection DDS bit 0; DDS select., bit 0; p0821[0...n] BI: Drive data set selection DDS bit 1; DDS select., bit 1; p0822[0...n] BI: Drive data set selection DDS bit 2; DDS select., bit 2; p0823[0...n] BI: Drive data set selection DDS bit 3; DDS select., bit 3

Parameters
List of parameters
1-242
© Siemens AG 2007 All Rights Reserved
SINAMICS S List Manual (LH1), 07/2007
Description: Sets the signal source to select the Drive Data Set, bit 0 (DDS, bit 0).
Dependency: Refer to: r0051, r0837
Notice: The parameter may be protected as a result of p0922 or p2079 and cannot be changed.
Description: Sets the signal source to select the Drive Data Set, bit 1 (DDS, bit 1).
Dependency: Refer to: r0051, r0837
Notice: The parameter may be protected as a result of p0922 or p2079 and cannot be changed.
Description: Sets the signal source to select the Drive Data Set, bit 2 (DDS, bit 2).
Dependency: Refer to: r0051, r0837
Notice: The parameter may be protected as a result of p0922 or p2079 and cannot be changed.
Description: Sets the signal source to select the Drive Data Set, bit 3 (DDS, bit 3).
Dependency: Refer to: r0051, r0837
Notice: The parameter may be protected as a result of p0922 or p2079 and cannot be changed.
p0820[0...n] BI: Drive data set selection DDS bit 0 / DDS select., bit 0
SERVO, TM41, VEC-
TOR
Can be changed: C2(15), T Calculated: - Access level: 3
Data type: Unsigned32 / Binary Dynamic index: CDS, p0170 Func. diagram: 8565
P-Group: Data sets Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - 0
p0821[0...n] BI: Drive data set selection DDS bit 1 / DDS select., bit 1
SERVO, TM41, VEC-
TOR
Can be changed: C2(15), T Calculated: - Access level: 3
Data type: Unsigned32 / Binary Dynamic index: CDS, p0170 Func. diagram: 8565
P-Group: Data sets Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - 0
p0822[0...n] BI: Drive data set selection DDS bit 2 / DDS select., bit 2
SERVO, TM41, VEC-
TOR
Can be changed: C2(15), T Calculated: - Access level: 3
Data type: Unsigned32 / Binary Dynamic index: CDS, p0170 Func. diagram: 8565
P-Group: Data sets Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - 0
p0823[0...n] BI: Drive data set selection DDS bit 3 / DDS select., bit 3
SERVO, TM41, VEC-
TOR
Can be changed: C2(15), T Calculated: - Access level: 3
Data type: Unsigned32 / Binary Dynamic index: CDS, p0170 Func. diagram: 8565
P-Group: Data sets Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - 0