Siemens SINAMICS S Series - r0899.0...15 CO;BO: Status word sequence control; ZSW seq

To Next Page

To Previous Page

List of parameters

Parameters

1-261

SINAMICS S List Manual (LH1), 07/2007

Note: Re bit 0, 1, 2, 4, 5, 6, 9:

For PROFIdrive, these signals are used for status word 1.

Re bit 13:

When the "Safe Brake Control" (SBC) is activated and selected, the brake is no longer controlled using this signal.

Re bit 14, 15:

These signals are only of significance when the "extended brake control" function module is activated (r0108.14 =

1).

Description: Displays the status word of the sequence control.

Note: Re bit 0, 1, 2, 6:

For PROFIdrive, these signals are used for status word 1.

r0899.0...15 CO/BO: Status word sequence control / ZSW seq_ctrl

TM41 Can be changed: - Calculated: - Access level: 2

Data type: Unsigned16 Dynamic index: - Func. diagram: 9680

P-Group: Displays, signals Units group: - Unit selection: -

Not for motor type: - Expert list: 1

Min Max Factory setting

- - -

Bit field: Bit Signal name 1 signal 0 signal FP

00 Ready to power up Yes No -

01 Ready Yes No -

02 Operation enabled Yes No -

04 Coast down active No Yes -

05 Quick Stop active No Yes -

06 Power-on inhibit Yes No -

09 Control requested Yes No -

13 Zero mark enabled Yes No -

14 Track A/B enabled Yes No -

15 Interface encoder emulation enabled Yes No -

Siemens SINAMICS S Series - r0899.0...15 CO;BO: Status word sequence control; ZSW seq_ctrl