Siemens SINAMICS S Series - r4270 TM15 set;reset time digital output 20; TM15 t_set DO 20; r4271 TM15 set;reset time digital output 21; TM15 t_set DO 21; r4272 TM15 set;reset time digital output 22; TM15 t_set DO 22; r4273 TM15 set;reset time digital output 23; TM15 t_set DO 23

Parameters
List of parameters
1-840
© Siemens AG 2007 All Rights Reserved
SINAMICS S List Manual (LH1), 07/2007
Description: Displays the time to set and reset for digital output 20 of terminal module 15 (TM15).
The two times are specified as 8 bit values with a resolution of 64 µs.
Note: DO: Digital Output
Description: Displays the time to set and reset for digital output 21 of terminal module 15 (TM15).
The two times are specified as 8 bit values with a resolution of 64 µs.
Note: DO: Digital Output
Description: Displays the time to set and reset for digital output 22 of terminal module 15 (TM15).
The two times are specified as 8 bit values with a resolution of 64 µs.
Note: DO: Digital Output
Description: Displays the time to set and reset for digital output 23 of terminal module 15 (TM15).
The two times are specified as 8 bit values with a resolution of 64 µs.
Note: DO: Digital Output
r4270 TM15 set/reset time digital output 20 / TM15 t_set DO 20
TM15 Can be changed: - Calculated: - Access level: 3
Data type: Unsigned16 Dynamic index: - Func. diagram: -
P-Group: Commands Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - -
r4271 TM15 set/reset time digital output 21 / TM15 t_set DO 21
TM15 Can be changed: - Calculated: - Access level: 3
Data type: Unsigned16 Dynamic index: - Func. diagram: -
P-Group: Commands Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - -
r4272 TM15 set/reset time digital output 22 / TM15 t_set DO 22
TM15 Can be changed: - Calculated: - Access level: 3
Data type: Unsigned16 Dynamic index: - Func. diagram: -
P-Group: Commands Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - -
r4273 TM15 set/reset time digital output 23 / TM15 t_set DO 23
TM15 Can be changed: - Calculated: - Access level: 3
Data type: Unsigned16 Dynamic index: - Func. diagram: -
P-Group: Commands Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - -