Siemens SINAMICS S Series - r2231 Technology controller motorized potentiometer setpoint memory; Tec_ctrl mop mem; p2235[0...n] BI: Technology controller motorized potentiometer raise setpoint; Tec_ctrl mop raise; p2236[0...n] BI: Technology controller motorized potentiometer lower setpoint; Tec_ctrl mop lower; p2237[0...n] Technology controller motorized potentiometer maximum value; Tec_ctrl mop max

List of parameters
Parameters
1-611
© Siemens AG 2007 All Rights Reserved
SINAMICS S List Manual (LH1), 07/2007
- Control Unit 320 (CU320) with hardware version C or higher (module with NVRAM).
Description: Displays the setpoint memory for the motorized potentiometer of the technology controller.
For p2230.0 = 1, the last setpoint that was saved is entered after ON.
Dependency: Refer to: p2230
Description: Sets the signal source to increase the setpoint for the motorized potentiometer of the technology controller.
Dependency: Refer to: p2236
Description: Sets the signal source to reduce the setpoint for the motorized potentiometer of the technology controller.
Dependency: Refer to: p2235
Description: Sets the maximum value for the motorized potentiometer of the technology controller.
Dependency: Refer to: p2238
r2231 Technology controller motorized potentiometer setpoint memory /
Tec_ctrl mop mem
SERVO (Tech_ctrl),
VECTOR (Tech_ctrl)
Can be changed: - Calculated: - Access level: 2
Data type: Floating Point Dynamic index: - Func. diagram: 7954
P-Group: Technology Units group: 9_1 Unit selection: p0595
Not for motor type: - Expert list: 1
Min Max Factory setting
- [%] - [%] - [%]
p2235[0...n] BI: Technology controller motorized potentiometer raise setpoint /
Tec_ctrl mop raise
SERVO (Tech_ctrl),
VECTOR (Tech_ctrl)
Can be changed: T Calculated: - Access level: 3
Data type: Unsigned32 / Binary Dynamic index: CDS, p0170 Func. diagram: 7954
P-Group: Commands Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - 0
p2236[0...n] BI: Technology controller motorized potentiometer lower setpoint /
Tec_ctrl mop lower
SERVO (Tech_ctrl),
VECTOR (Tech_ctrl)
Can be changed: T Calculated: - Access level: 3
Data type: Unsigned32 / Binary Dynamic index: CDS, p0170 Func. diagram: 7954
P-Group: Commands Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - 0
p2237[0...n] Technology controller motorized potentiometer maximum value / Tec_ctrl mop max
SERVO (Tech_ctrl),
VECTOR (Tech_ctrl)
Can be changed: U, T Calculated: - Access level: 2
Data type: Floating Point Dynamic index: DDS, p0180 Func. diagram: 7954
P-Group: Technology Units group: 9_1 Unit selection: p0595
Not for motor type: - Expert list: 1
Min Max Factory setting
-200.00 [%] 200.00 [%] 100.00 [%]