Index
D-1811
© Siemens AG 2007 All Rights Reserved
SINAMICS S List Manual (LH1), 07/2007
T
T - status Ready to run, 1-18
Target group, Foreword-6
Technical Support, Foreword-7
Technology controller (p0108.16 = 1), 2-1322
Technology functions, 2-1314
Telegrams, 2-1147
Terminal Board 30 (TB30)
Analog inputs/outputs, 2-1374
Digital inputs/outputs, 2-1374
Terminal Module 15 for SINAMICS
(TM15DI/DO), 2-1386
Terminal Module 31 (TM31), 2-1390
Analog inputs/outputs, 2-1390
Digital inputs/outputs, 2-1390
Relay outputs, 2-1390
Terminal Module 41 (TM41), 2-1401
Terminals
Control Unit 310 (CU310), 2-1130
Control Unit 320 (CU320), 2-1134
Controller extension 32 (CX32), 2-1143
Terminal Board 30 (TB30), 2-1374
Terminal Module 31 (TM31), 2-1390
Thermal monitoring, 2-1326
Torque signals, 2-1326
Triggering on messages (r2129), 2-1333
U
U - status Run, 1-18
Unit (Parameter), 1-22
Usage phases, Foreword-5
V
V/f control
Servo, 2-1275
Vector, 2-1293
Values (Parameter), 1-26
Variable parameters, 1-13
Vector control
Current setpoint filter, 2-1301
Droop Function, 2-1287
Encoder evaluation, 2-1258
Field weakening characteristic, Id set-
point, 2-1304
Flux control, 2-1297
Iq and Id controller, 2-1302
Kp_n-/Tn_n adaptation, 2-1290
Resonance damping and slip compensati-
on, 2-1294
Speed control configuration, 2-1296
Speed controller with / without encoder,
2-1289
Table of contents, 2-1286
Torque setpoint, 2-1291
V/f characteristic, 2-1293
Vdc_max controller and
Vdc_min controller, 2-1295
Version
List of all parameters, 1-30
List of faults and alarms, 3-1434
List of parameters for
Command Data Sets, 1-1069
List of parameters for
Drive Data Sets, 1-1072
List of parameters for
Encoder Data Sets, 1-1082
List of parameters for
Motor Data Sets, 1-1084
List of parameters for
Power unit Data Sets, 1-1087
Voltage Sensing Module (VSM)
Analog inputs, 2-1414
Sensor monitoring KTY/PTC, 2-1414
Temperature evaluation, 2-1414
To Next Page
Loading...
