Parameters
Overview of parameters
1-28
© Siemens AG 2007 All Rights Reserved
SINAMICS S List Manual (LH1), 07/2007
1.1.2 Numerical ranges of parameters
Parameters are grouped into the following numerical ranges:
Note:
The following numerical ranges for the parameters represent a complete overview
of SINAMICS.
The parameters for the product described in this List Manual are described in
detail in Chapter 1.2.
Table 1-7 Numerical Ranges of Parameters
Range Description
of to
0000 0099 Operation and visualization
0100 0199 Commissioning
0200 0299 Power unit
0300 0399 Motor
0400 0499 Encoder
0500 0599 Technology and units
0600 0699 Thermal motor protection and motor model, maximum current
0700 0799 Command sources and terminals on Control Unit, measuring
sockets
0800 0839 CDS, DDS data sets (e.g. switch over, copy)
0840 0879 Sequencer (e.g. source for ON/OFF1)
0880 0899 Control and status words
0900 0999 PROFIBUS/PROFIdrive
1000 1199 Setpoint channel
1200 1299 Functions (e.g. motor holding brake)
1300 1399 V/f control
1400 1799 Closed-loop control
1800 1899 Gating unit
1900 1999 Power unit and motor identification
2000 2099 Communication (PROFIBUS)
2100 2199 Faults and alarms, monitoring functions
2200 2399 Technology controller
2900 2930 Fixed values (e.g. per cent, torque)
3400 3699 Infeed control (Active Line Module)
3800 3899 Friction characteristic
To Next Page
Loading...
