Parameters
Overview of parameters
1-12
© Siemens AG 2007 All Rights Reserved
SINAMICS S List Manual (LH1), 07/2007
1.1 Overview of parameters
1.1.1 Explanation of list of parameters
Basic structure of parameter descriptions
The data in the following example has been chosen at random. The table below
shows all the information which can be included in the description of a parameter.
Some of the information is optional.
The structure of the parameter list (See Section 1.2) is as follows:
- - - - - - - - - - - - - - - - - - - - Start of example- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Description: Text
alues: 0: Name and meaning of value 0
1: Name and meaning of value 1
2: Name and meaning of value 2
etc.
Recommenda-
tion:
Text
Index: [0] = Name and meaning of index 0
[1] = Name and meaning of index 1
[2] = Name and meaning of index 2
etc.
Depends on: Text
See also: pxxxx, rxxxx
See also: Fxxxxx, Axxxxx
Note: Information which might be useful.
- - - - - - - - - - - - - - - - - - - - End of example- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
pxxxx[0...n] BICO: Full parameter name / Abbreviated name
Drive object
(function module)
Changeable in: C1(x), C2(x), U, T are calculated: CALC_MOD_REG Access level: 2
Data type: Unsigned32 / Integer16 Dynamic index: CDS, p0170 Function diagram: 2080
P group: Cl.-lp. control Unit Group: 7_1 Unit selection: p0505
Not for motor type: FEM Expert list: 1
Min Max Factory setting
0.00 [Nm] 10.00 [Nm] 0.00 [Aeff]
Bit array: Bit Signal name 1 signal 0 signal FP
00 Name and meaning of bit 0 Yes No 8010
01 Name and meaning of bit 1 Yes No -
02 Name and meaning of bit 2 Yes No 8012
etc.
Danger: Warning: Caution: Safety-related information with a safety alert symbol
Caution: Notice: Safety-related information without a safety alert symbol
To Next Page
Loading...
Need help?
General
