Parameters
List of parameters
1-826
© Siemens AG 2007 All Rights Reserved
SINAMICS S List Manual (LH1), 07/2007
Note: DI/DO: Bidirectional Digital Input/Output
Description: Used to control digital output 0 ... 15 of terminal module 15 (TM15).
Note: DI/DO: Bidirectional Digital Input/Output
Description: Used to control digital output 16 ... 23 of terminal module 15 (TM15).
Note: DI/DO: Bidirectional Digital Input/Output
09 DI/DO 9 (X521.9) On Off -
10 DI/DO 10 (X522.2) On Off -
11 DI/DO 11 (X522.3) On Off -
12 DI/DO 12 (X522.5) On Off -
13 DI/DO 13 (X522.6) On Off -
14 DI/DO 14 (X522.8) On Off -
15 DI/DO 15 (X522.9) On Off -
r4204 TM15 control digital output 0 ... 15 / TM15 ctrl DO 0-15
TM15 Can be changed: - Calculated: - Access level: 3
Data type: Unsigned16 Dynamic index: - Func. diagram: -
P-Group: Commands Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - -
Bit field: Bit Signal name 1 signal 0 signal FP
00 DI/DO 0 (X520.2) On Off -
01 DI/DO 1 (X520.3) On Off -
02 DI/DO 2 (X520.4) On Off -
03 DI/DO 3 (X520.5) On Off -
04 DI/DO 4 (X520.6) On Off -
05 DI/DO 5 (X520.7) On Off -
06 DI/DO 6 (X520.8) On Off -
07 DI/DO 7 (X520.9) On Off -
08 DI/DO 8 (X521.2) On Off -
09 DI/DO 9 (X521.3) On Off -
10 DI/DO 10 (X522.4) On Off -
11 DI/DO 11 (X521.5) On Off -
12 DI/DO 12 (X521.6) On Off -
13 DI/DO 13 (X521.7) On Off -
14 DI/DO 14 (X521.8) On Off -
15 DI/DO 15 (X521.9) On Off -
r4205 TM15 control digital output 16 ... 23 / TM15 ctrl DO 16-23
TM15 Can be changed: - Calculated: - Access level: 3
Data type: Unsigned16 Dynamic index: - Func. diagram: -
P-Group: Commands Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - -
Bit field: Bit Signal name 1 signal 0 signal FP
00 DI/DO 16 (X522.2) On Off -
01 DI/DO 17 (X522.3) On Off -
02 DI/DO 18 (X522.4) On Off -
03 DI/DO 19 (X522.5) On Off -
04 DI/DO 20 (X522.6) On Off -
05 DI/DO 21 (X522.7) On Off -
06 DI/DO 22 (X522.8) On Off -
07 DI/DO 23 (X522.9) On Off -
To Next Page
Loading...
