Siemens SINAMICS S Series - r1548[0...1] CO: Stall current limit torque-generating maximum; Isq_max stall; r1549 CO: Stall power actual value; P_stall; p1550[0...n] BI: Transfer actual torque as torque offset; Accept act torque; p1550[0...n] BI: Transfer actual force as force offset; Accept act force

List of parameters
Parameters
1-443
© Siemens AG 2007 All Rights Reserved
SINAMICS S List Manual (LH1), 07/2007
Description: Displays the limit for the torque-generating current component using the stall calculation, the current limit of the
Motor Module as well as the parameterization in p0640.
Index: [0] = Upper limit
[1] = Lower limit
Description: Displays the instantaneous stall power.
Dependency: Refer to: p0326
Description: For a positive edge, the actual torque (r0079[0]) at this instant in time is used instead of the torque offset from
p1532 as long as p1550 remains at 1.
Description: For a positive edge, the actual force (r0079[0]) at this instant in time is used instead of the force offset from p1532
as long as p1550 remains at 1.
r1548[0...1] CO: Stall current limit torque-generating maximum / Isq_max stall
VECTOR (n/M) Can be changed: - Calculated: - Access level: 4
Data type: Floating Point Dynamic index: - Func. diagram: -
P-Group: Closed-loop control Units group: 6_2 Unit selection: p0505
Not for motor type: REL Expert list: 1
Min Max Factory setting
- [Arms] - [Arms] - [Arms]
r1549 CO: Stall power actual value / P_stall
SERVO Can be changed: - Calculated: - Access level: 3
Data type: Floating Point Dynamic index: - Func. diagram: -
P-Group: Displays, signals Units group: 14_5 Unit selection: p0505
Not for motor type: - Expert list: 1
Min Max Factory setting
- [kW] - [kW] - [kW]
p1550[0...n] BI: Transfer actual torque as torque offset / Accept act torque
SERVO Can be changed: T Calculated: - Access level: 2
Data type: Unsigned32 / Binary Dynamic index: CDS, p0170 Func. diagram: -
P-Group: Closed-loop control Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - 9718.23
p1550[0...n] BI: Transfer actual force as force offset / Accept act force
SERVO (Lin) Can be changed: T Calculated: - Access level: 2
Data type: Unsigned32 / Binary Dynamic index: CDS, p0170 Func. diagram: -
P-Group: Closed-loop control Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - 9718.23