Terminal Module 41 (TM41)
Function Diagrams
2-1409
© Siemens AG 2007 All Rights Reserved
SINAMICS S List Manual (LH1), 07/2007
Figure 2-276 9680 – Status word sequence control
- 9680 -
Function diagram
87654321
fp_9680_51_eng.vsd
DO: TM41
SINAMICS
13.03.07 V02.05.00
Terminal Module 41 (TM41) - Status word, sequence control
11
12
13
14
15
r0899
ZSW seq_ctrl
<1> Process data is requested from the control system.
PROFIdrive-Bit
Bit Nr.
10
9
8
7
6
5
4
3
0
1
2
From the sequence control [9682]
From the sequence control [9682]
From the sequence control [9678.7]
From the sequence control [9682]
From the sequence control [9682]
From the sequence control [9678.7]
2000.00 µs
r0899.0
r0899.1
r0899.4
r0899.5
r0899.2
r0899.6
r0899.9
1 = Ready to run
1 = Ready to power-up
Status word sequence control
1 = Operation enabled
Reserved
1 = No coast down active (OFF2 inactive)
1 = No fast stop active (OFF3 inactive)
1 = Power-on inhibit active
Reserved
Reserved
1 = Control requested <1>
Reserved
Reserved
Reserved
1 = Zero mark enabled
1 = Interface encoder simulation enabled
1 = Tracks A/B enabled
Bit 9 = 1 --> ready to exchange process data
r0899.13
r0899.14
r0899.15From TM41 Impulse encoder simulation (HW)
r0899.8
From TM41 Impulse encoder simulation (HW)
From TM41 Impulse encoder simulation (HW)
To Next Page
Loading...
