Parameters
List of parameters
1-912
© Siemens AG 2007 All Rights Reserved
SINAMICS S List Manual (LH1), 07/2007
Description: Parameter to display a DSA signal in the float format.
The associated signal number is represented at the appropriate index in r7831.
Index: [0] =
[1] =
[2] =
[3] =
[4] =
[5] =
[6] =
[7] =
[8] =
[9] =
[10] =
[11] =
[12] =
[13] =
[14] =
[15] =
Description: Parameter to display the units of a DSA signal.
The associated signal number is represented at the appropriate index in r7831.
Values: -1: Unknown
0: None
1: Millimeter or degrees
2: Millimeter
3: Degrees
4: mm/min or RPM
5: Millimeter / min
6: Revolutions / min
7: m/sec^2 or V/sec^2
8: m/sec^2
9: V/sec^2
10: m/sec^3 or V/sec^3
11: m/sec^3
12: V/sec^3
13: Sec
14: 16.667 / sec
15: mm/revolution
16: ACX_UNIT_COMPENSATION_CORR
18: Newton
19: Kilogram
20: Kilogram meter ^2
21: Percent
r7835[0...15] Telegram diagnostics real / Tel diag real
SERVO, VECTOR Can be changed: - Calculated: - Access level: 4
Data type: Floating Point Dynamic index: - Func. diagram: -
P-Group: - Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - -
r7836[0...15] Telegram diagnostics unit / Tel diag unit
SERVO, VECTOR Can be changed: - Calculated: - Access level: 4
Data type: Integer16 Dynamic index: - Func. diagram: -
P-Group: - Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
-1 147 -
To Next Page
Loading...
