Siemens SINAMICS S Series - r3928[0...n] Rotating measurement configuration; Rot meas config; p3950 Service parameter; Service parameter; r3977 BICO counter, topology; BICO counter topo; r3978 BICO CounterDevice; BICO CounterDevice

List of parameters
Parameters
1-769
© Siemens AG 2007 All Rights Reserved
SINAMICS S List Manual (LH1), 07/2007
Dependency: Refer to: r3925
Note: The parameter is a copy of p1959.
Description: Successfully completed component of the last rotating measurement carried out.
Dependency: Refer to: r3925
Note: The parameter is a copy of p1959.
Description: For service personnel only.
Description: Displays the BICO interconnections that have been parameterized in the complete (overall) topology.
The counter is incremented by one for each modified BICO interconnection.
Dependency: Refer to: r3978, r3979
Description: For each modified BICO interconnection of this device, the counter is incremented by one. Displays this counter.
r3928[0...n] Rotating measurement configuration / Rot meas config
VECTOR (n/M) Can be changed: - Calculated: CALC_MOD_ALL Access level: 3
Data type: Unsigned16 Dynamic index: DDS, p0180 Func. diagram: -
P-Group: Motor identification Units group: - Unit selection: -
Not for motor type: REL Expert list: 1
Min Max Factory setting
- - -
Bit field: Bit Signal name 1 signal 0 signal FP
00 Enc test active Yes No -
01 Saturation characteristic identification Yes No -
02 Moment of inertia identification Yes No -
03 Recalculates the speed controller parame-
ters
Yes No -
04 Speed controller optimization, (vibration
test)
Yes No -
05 q leakage inductance ident. (for current con-
troller adaptation)
Yes No -
p3950 Service parameter / Service parameter
CU_CX32, CU_S Can be changed: C1, U, T Calculated: - Access level: 3
Data type: Unsigned16 Dynamic index: - Func. diagram: -
P-Group: - Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - -
r3977 BICO counter, topology / BICO counter topo
CU_CX32, CU_S Can be changed: - Calculated: - Access level: 4
Data type: Unsigned32 Dynamic index: - Func. diagram: -
P-Group: Commands Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - -
r3978 BICO CounterDevice / BICO CounterDevice
CU_CX32, CU_S Can be changed: - Calculated: - Access level: 4
Data type: Unsigned32 Dynamic index: - Func. diagram: -
P-Group: Commands Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - -