Siemens SINAMICS S Series - r3575.0...2 BO: Master;slave DC link voltage monitoring status; Vdc monit status; r3602 Infeed control status; INF ctrl state; p3603 Infeed current pre-control factor D component; INF I_ctrl D�comp; r3606 Infeed active current controller system deviation; INF I_act ctrl dev

List of parameters
Parameters
1-719
© Siemens AG 2007 All Rights Reserved
SINAMICS S List Manual (LH1), 07/2007
Description: Displays the status of the DC link voltage monitoring for the master/slave.
Dependency: Refer to: r0088, p3510, p3574
Description: Displays the status of the closed-loop infeed control.
Values: 0: Initialization running
1: Pulse enable missing
2: Ramp-up, DC-link voltage
3: Ramp-up reactive current
4: Shutdown running
5: Reset identification
6: Operation
7: Identification running
8: Smart mode running
Description: The D component of the current pre-control is determined from the device data of the filter. p3603 can be used to
weigh the pre-calculated D component. If no dynamic pre-control is to be used, set the factor to zero.
Description: Displays the system deviation of the active current controller.
r3575.0...2 BO: Master/slave DC link voltage monitoring status / Vdc monit status
A_INF (Mas-
ter/Slave)
Can be changed: - Calculated: - Access level: 3
Data type: Unsigned32 Dynamic index: - Func. diagram: 8948
P-Group: Commands Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - -
Bit field: Bit Signal name 1 signal 0 signal FP
00 Upper limit value reached Yes No -
01 Lower limit value reached Yes No -
02 Upper/lower limit value reached Yes No -
r3602 Infeed control status / INF ctrl state
A_INF Can be changed: - Calculated: - Access level: 4
Data type: Integer16 Dynamic index: - Func. diagram: -
P-Group: Closed-loop control Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
0000 bin 1000 bin -
p3603 Infeed current pre-control factor D component / INF I_ctrl D-comp
A_INF Can be changed: U, T Calculated: - Access level: 4
Data type: Floating Point Dynamic index: - Func. diagram: 8946
P-Group: Closed-loop control Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
0.00 [%] 500.00 [%] 100.00 [%]
r3606 Infeed active current controller system deviation / INF I_act ctrl dev
A_INF Can be changed: - Calculated: - Access level: 2
Data type: Floating Point Dynamic index: - Func. diagram: 8946
P-Group: Closed-loop control Units group: 6_2 Unit selection: p0505
Not for motor type: - Expert list: 1
Min Max Factory setting
- [Arms] - [Arms] - [Arms]