Siemens SINAMICS S Series - Figure 2-116 3040 - Direction limiting and direction reversal

Setpoint channel
Function Diagrams
2-1229
© Siemens AG 2007 All Rights Reserved SINAMICS S List Manual (LH1), 07/2007
Figure 2-116 3040 – Direction limiting and direction reversal
- 3040 -
Function diagram
87654321
fp_3040_51_eng.vsd
DO: SERVO, VECTOR, VECTORGL, VECTORMV
SINAMICS
27.03.07 V02.05.00
Setpoint channel - Direction limitation and direction reversal
r1114
Setp after lim
n_set_1
[3030.8] [3050.1]
1 = Direction reversal
r1198.11
-1
0
1
1 = Inhibit negative direction of rotation
r1198.5
1 = Inhibit positive direction of rotation
r1198.6
[2505.5]
p1110
[2505.7]
p1111
[2505.7]
p1113
<1> AOP30 for SINAMICS GM150 only.
<2> Only active in LOCAL mode (r0807.0 = 1) [2501.2]
<100> For SERVO, the following applies: Only if the function module “extended setpoint channel“ is activated (r0108.8 = 1).
<101> To view the pre-assignment of the sampling times in p0115, refer to p0112.
<100>
<101>
p0115[3]
Refer to [1020.7]
0
1
0
0
1
0
AOP30
JOG
LOCAL
REMOTE
I
O
<2>
n_limit setp
p1063[D]
<1>