Siemens SINAMICS S Series - r2134[0...63] Alarm value for float values; Alarm value float; r2135.0...15 CO;BO: Status word faults;alarms 2; ZSW fault;alarm 2

To Next Page

To Previous Page

Parameters

List of parameters

1-582

SINAMICS S List Manual (LH1), 07/2007

Description: Displays additional information about the active alarm for float values.

Dependency: Refer to: r2110, r2122, r2123, r2124, r2125, r2145, r2146

Note: The buffer parameters are cyclically updated in the background (refer to status signal in r2139).

Description: Displays the second status word of faults and alarms.

r2134[0...63] Alarm value for float values / Alarm value float

All objects Can be changed: - Calculated: - Access level: 3

Data type: Floating Point Dynamic index: - Func. diagram: 8065

P-Group: Messages Units group: - Unit selection: -

Not for motor type: - Expert list: 1

Min Max Factory setting

- - -

r2135.0...15 CO/BO: Status word faults/alarms 2 / ZSW fault/alarm 2

A_INF, B_INF,

CU_CX32, CU_LINK,

CU_S, DMC20,

SERVO, S_INF,

TB30, TM15,

TM15DI_DO, TM17,

TM31, TM41,

TM54F_MA,

TM54F_SL

Can be changed: - Calculated: - Access level: 2

Data type: Unsigned16 Dynamic index: - Func. diagram: 1530, 2548

P-Group: Displays, signals Units group: - Unit selection: -

Not for motor type: - Expert list: 1

Min Max Factory setting

- - -

Bit field: Bit Signal name 1 signal 0 signal FP

00 Fault encoder 1 Yes No -

01 Fault encoder 2 Yes No -

02 Fault encoder 3 Yes No -

10 Fault transformer overtemperature Yes No -

11 Alarm transformer overtemperature Yes No -

12 Fault motor overtemperature Yes No -

13 Fault thermal overload power unit Yes No -

14 Alarm motor overtemperature Yes No -

15 Alarm power unit thermal overload Yes No -

r2135.0...15 CO/BO: Status word faults/alarms 2 / ZSW fault/alarm 2

VECTOR Can be changed: - Calculated: - Access level: 2

Data type: Unsigned16 Dynamic index: - Func. diagram: 1530, 2548

P-Group: Displays, signals Units group: - Unit selection: -

Not for motor type: - Expert list: 1

Min Max Factory setting

- - -

Bit field: Bit Signal name 1 signal 0 signal FP

00 Fault encoder 1 Yes No -

01 Fault encoder 2 Yes No -

02 Fault encoder 3 Yes No -

12 Fault motor overtemperature Yes No -

13 Fault thermal overload power unit Yes No -

14 Alarm motor overtemperature Yes No -

15 Alarm power unit thermal overload Yes No -

Main Page

Siemens SINAMICS S Series - r2134[0...63] Alarm value for float values; Alarm value float; r2135.0...15 CO;BO: Status word faults;alarms 2; ZSW fault;alarm 2

Table of Contents

Related product manuals