Siemens SINAMICS S Series - r2092.0...15 BO: IF1 PROFIdrive PZD3 receive bit-serial; IF1 PZD3 recv bitw; r2093.0...15 BO: IF1 PROFIdrive PZD4 receive bit-serial; IF1 PZD4 recv bitw

To Next Page

To Previous Page

Parameters

List of parameters

1-564

SINAMICS S List Manual (LH1), 07/2007

Note: IF1: Interface 1

Description: Binector output for bit-serial interconnection of PZD3 received from the PROFIBUS master.

Note: IF1: Interface 1

Description: Binector output for bit-serial interconnection of PZD4 (normally control word 2) received from the PROFIBUS mas-

ter.

Bit field: Bit Signal name 1 signal 0 signal FP

00 Bit 0 On Off -

01 Bit 1 On Off -

02 Bit 2 On Off -

03 Bit 3 On Off -

04 Bit 4 On Off -

05 Bit 5 On Off -

06 Bit 6 On Off -

07 Bit 7 On Off -

08 Bit 8 On Off -

09 Bit 9 On Off -

10 Bit 10 On Off -

11 Bit 11 On Off -

12 Bit 12 On Off -

13 Bit 13 On Off -

14 Bit 14 On Off -

15 Bit 15 On Off -

r2092.0...15 BO: IF1 PROFIdrive PZD3 receive bit-serial / IF1PZD3recvbitw

SERVO, TM41, VEC-

TOR

Can be changed: - Calculated: - Access level: 3

Data type: Unsigned16 Dynamic index: - Func. diagram: 2460

P-Group: Communications Units group: - Unit selection: -

Not for motor type: - Expert list: 1

Min Max Factory setting

- - -