List of parameters
Parameters
1-43
© Siemens AG 2007 All Rights Reserved
SINAMICS S List Manual (LH1), 07/2007
Description: Runs the appropriate ACX file on the CompactFlash card.
The selected ACX file must be located in the following directory:
... /PMACROS/DEVICE/P15/PMxxxxxx.ACX
Example:
p0015 = 6 --> the file PM000006.ACX is run.
Dependency: The ACX file to be run must be created according to the definition for ACX macros and must be saved in the direc-
tory intended on the CompactFlash card.
Refer to: p0700, p1000, p1500, r8570
Note: The macros in the specified directory are displayed in r8570. r8570 is not in the Expert list of the commissioning
software.
Macros available as standard are described in the technical documentation of the particular product.
Description: Runs the appropriate ACX file on the CompactFlash card.
The selected ACX file must be located in the following directory:
... /PMACROS/<drive object>/P15/PMxxxxxx.ACX
Example:
p0015 = 6 --> the file PM000006.ACX is run.
Dependency: The ACX file to be run must be created according to the definition for ACX macros and must be saved in the direc-
tory intended on the CompactFlash card.
Refer to: p0700, p1000, p1500, r8570
Notice: No errors were issued during fast commissioning (p3900 = 1) when writing to parameters of the QUICK_IBN group!
Note: The macros in the specified directory are displayed in r8570. r8570 is not in the Expert list of the commissioning
software.
Macros available as standard are described in the technical documentation of the particular product.
Description: Displays the firmware version of the Control Unit.
Dependency: Refer to: r0128, r0148, r0158, r0197, r0198
Note: Example:
The value 1010100 should be interpreted as V01.01.01.00.
p0015 Macro drive unit / Macro drv unit
CU_CX32, CU_S Can be changed: C1 Calculated: - Access level: 1
Data type: Unsigned32 Dynamic index: - Func. diagram: -
P-Group: - Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
0 999999 0
p0015 Macro drive object / Macro DO
A_INF, B_INF,
SERVO, S_INF,
TM15DI_DO, TM31,
VECTOR
Can be changed: C2(1) Calculated: - Access level: 1
Data type: Unsigned32 Dynamic index: - Func. diagram: -
P-Group: Commands Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
0 999999 0
r0018 Control Unit Firmware-Version / CU FW version
CU_CX32, CU_S Can be changed: - Calculated: - Access level: 1
Data type: Unsigned32 Dynamic index: - Func. diagram: -
P-Group: - Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - -
To Next Page
Loading...
