Parameters
List of parameters
1-286
© Siemens AG 2007 All Rights Reserved
SINAMICS S List Manual (LH1), 07/2007
[7] = Reserved
[8] = Reserved
[9] = Reserved
[10] = Reserved
Note: Information about the individual indices can be taken from the following literature:
PROFIdrive Profile Drive Technology
Description: Displays the parameters that exist for this drive.
Dependency: Refer to: r0981, r0989
Note: The existing parameters are displayed in indices 0 to 98. If an index contains the value 0, then the list ends here. In
a long list, index 99 contains the parameter number at which position the list continues.
This list completely comprises the following parameters:
r0980[0...99], r0981[0...99] ... r0989[0...99]
The parameters in this list are not displayed in the expert list of the commissioning software. However, they can be
read from a higher-level control system (e.g. PROFIBUS master).
Description: Displays the parameters that exist for this drive.
Dependency: Refer to: r0980, r0989
Note: The existing parameters are displayed in indices 0 to 98. If an index contains the value 0, then the list ends here. In
a long list, index 99 contains the parameter number at which position the list continues.
This list completely comprises the following parameters:
r0980[0...99], r0981[0...99] ... r0989[0...99]
The parameters in this list are not displayed in the expert list of the commissioning software. However, they can be
read from a higher-level control system (e.g. PROFIBUS master).
r0980[0...199] List of existing parameters 1 / List avail par 1
A_INF, B_INF,
CU_CX32, CU_LINK,
CU_S, DMC20,
SERVO, S_INF,
TB30, TM15,
TM15DI_DO, TM17,
TM31, TM41, VEC-
TOR
Can be changed: - Calculated: - Access level: 4
Data type: Unsigned16 Dynamic index: - Func. diagram: -
P-Group: - Units group: - Unit selection: -
Not for motor type: - Expert list: 0
Min Max Factory setting
- - -
r0981[0...199] List of existing parameters 2 / List avail par 2
A_INF, B_INF,
CU_CX32, CU_LINK,
CU_S, DMC20,
SERVO, S_INF,
TB30, TM15,
TM15DI_DO, TM17,
TM31, TM41, VEC-
TOR
Can be changed: - Calculated: - Access level: 4
Data type: Unsigned16 Dynamic index: - Func. diagram: -
P-Group: - Units group: - Unit selection: -
Not for motor type: - Expert list: 0
Min Max Factory setting
- - -
To Next Page
Loading...
