Siemens SINAMICS S Series - r4791[0...1] Trace, data type 6 traced; Trace rec type 6; r4792[0...1] Trace, data type 7 traced; Trace rec type 7; r4793[0...1] Trace, data type 8 traced; Trace rec type 8; p4795 Trace memory bank changeover; Trace mem changeov

List of parameters
Parameters
1-877
© Siemens AG 2007 All Rights Reserved
SINAMICS S List Manual (LH1), 07/2007
Index: [0] = Trace 0
[1] = Trace 1
Index: [0] = Trace 0
[1] = Trace 1
Index: [0] = Trace 0
[1] = Trace 1
Description: Changes over the memory bank to read-out the contents of the trace buffer.
Dependency: Refer to: r4740, r4741, r4742, r4743, r4750, r4751, r4752, r4753
Description: Displays the free memory for the trace in bytes.
Dependency: Refer to: r4708
r4791[0...1] Trace, data type 6 traced / Trace rec type 6
CU_CX32, CU_S Can be changed: - Calculated: - Access level: 3
Data type: Unsigned32 Dynamic index: - Func. diagram: -
P-Group: Trace and function generator Units group: - Unit selection: -
Not for motor type: - Expert list: 0
Min Max Factory setting
- - -
r4792[0...1] Trace, data type 7 traced / Trace rec type 7
CU_CX32, CU_S Can be changed: - Calculated: - Access level: 3
Data type: Unsigned32 Dynamic index: - Func. diagram: -
P-Group: Trace and function generator Units group: - Unit selection: -
Not for motor type: - Expert list: 0
Min Max Factory setting
- - -
r4793[0...1] Trace, data type 8 traced / Trace rec type 8
CU_CX32, CU_S Can be changed: - Calculated: - Access level: 3
Data type: Unsigned32 Dynamic index: - Func. diagram: -
P-Group: Trace and function generator Units group: - Unit selection: -
Not for motor type: - Expert list: 0
Min Max Factory setting
- - -
p4795 Trace memory bank changeover / Trace mem changeov
CU_CX32, CU_S Can be changed: U, T Calculated: - Access level: 3
Data type: Unsigned32 Dynamic index: - Func. diagram: -
P-Group: Trace and function generator Units group: - Unit selection: -
Not for motor type: - Expert list: 0
Min Max Factory setting
0 500 0
r4799 Trace memory location free / Trace mem free
CU_CX32, CU_S Can be changed: - Calculated: - Access level: 3
Data type: Unsigned32 Dynamic index: - Func. diagram: -
P-Group: Trace and function generator Units group: - Unit selection: -
Not for motor type: - Expert list: 0
Min Max Factory setting
- - -