List of parameters
Parameters
1-233
© Siemens AG 2007 All Rights Reserved
SINAMICS S List Manual (LH1), 07/2007
Description: Sets the signal source for the signal to be output at the test sockets.
Index: [0] = T0
[1] = T1
[2] = T2
Dependency: Can only be set when p0776 = 99.
Refer to: r0772, r0774, p0776, p0777, p0778, p0779, p0780, p0783, p0784, r0786
Description: Displays the actual value of the signal to be output.
Index: [0] = T0
[1] = T1
[2] = T2
Dependency: Refer to: p0771, r0774, p0776, p0777, p0778, p0779, p0780, p0783, p0784, r0786
Description: Displays the actual output voltage for the test sockets.
Index: [0] = T0
[1] = T1
[2] = T2
Dependency: Refer to: p0771, r0772, p0776, p0777, p0778, p0779, p0780, p0783, p0784, r0786
Bit field: Bit Signal name 1 signal 0 signal FP
08 DI/DO 8 (X122.7) Inverted Not inverted -
09 DI/DO 9 (X122.8) Inverted Not inverted -
10 DI/DO 10 (X122.10) Inverted Not inverted -
11 DI/DO 11 (X122.11) Inverted Not inverted -
p0771[0...2] CI: Test sockets signal source / TestSktsSigSrce
CU_CX32, CU_S Can be changed: U, T Calculated: - Access level: 2
Data type: Unsigned32 / Integer16 Dynamic index: - Func. diagram: 8134
P-Group: Terminals Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - 0
r0772[0...2] Test sockets output signal / TestSktsSignalVal
CU_CX32, CU_S Can be changed: - Calculated: - Access level: 2
Data type: Floating Point Dynamic index: - Func. diagram: 8134
P-Group: Terminals Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- [%] - [%] - [%]
r0774[0...2] Test sockets output voltage / TestSkts V_output
CU_CX32, CU_S Can be changed: - Calculated: - Access level: 2
Data type: Floating Point Dynamic index: - Func. diagram: 8134
P-Group: Terminals Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- [V] - [V] - [V]
To Next Page
Loading...
