Parameters
List of parameters
1-924
© Siemens AG 2007 All Rights Reserved
SINAMICS S List Manual (LH1), 07/2007
Description: Sets the signal source for bitwise data transfer.
These signals are transferred to another Control Unit and are located in BO: r8511.0 ... 15 for further interconnec-
tion.
Index: [0] = Send signal to BO: r8511.0
[1] = Send signal to BO: r8511.1
[2] = Send signal to BO: r8511.2
[3] = Send signal to BO: r8511.3
[4] = Send signal to BO: r8511.4
[5] = Send signal to BO: r8511.5
[6] = Send signal to BO: r8511.6
[7] = Send signal to BO: r8511.7
[8] = Send signal to BO: r8511.8
[9] = Send signal to BO: r8511.9
[10] = Send signal to BO: r8511.10
[11] = Send signal to BO: r8511.11
[12] = Send signal to BO: r8511.12
[13] = Send signal to BO: r8511.13
[14] = Send signal to BO: r8511.14
[15] = Send signal to BO: r8511.15
Dependency: Refer to: r8511
p8501[0...15] BI: Data transfer 1 bitwise / Transfer 1 bit
CU_CX32 Can be changed: U, T Calculated: - Access level: 2
Data type: Unsigned32 / Binary Dynamic index: - Func. diagram: 2211
P-Group: - Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - [0] 722.0
[1] 722.1
[2] 722.2
[3] 722.3
[4] 0
[5] 0
[6] 0
[7] 0
[8] 722.8
[9] 722.9
[10] 722.10
[11] 722.11
[12] 0
[13] 0
[14] 0
[15] 0
To Next Page
Loading...
