Siemens SINAMICS S Series - r10052.0...3 CO;BO: SI digital outputs status; SI DO status; r10053.0...3 CO;BO: SI digital inputs 20... 23 status; SI DI 20...23 stat; r10054 SI TM54 F failsafe events active; SI failsafe event

List of parameters
Parameters
1-1065
© Siemens AG 2007 All Rights Reserved
SINAMICS S List Manual (LH1), 07/2007
Description: Displays the status of the digital outputs at the Terminal Module 54F (TM54F).
Note: F-DO: Failsafe Digital Output
Description: Displays the status of the digital inputs at the Terminal Module 54F (TM54F).
Description: Displays the events that lead to the transfer of failsafe signals to all drives assigned to the TM54F.
r10052.0...3 CO/BO: SI digital outputs status / SI DO status
TM54F_MA,
TM54F_SL
Can be changed: - Calculated: - Access level: 3
Data type: Unsigned32 Dynamic index: - Func. diagram: -
P-Group: Safety Integrated Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - -
Bit field: Bit Signal name 1 signal 0 signal FP
00 DO 0 High Low 2853
01 DO 1 High Low 2853
02 DO 2 High Low 2853
03 D0 3 High Low 2853
r10053.0...3 CO/BO: SI digital inputs 20 ... 23 status / SI DI 20...23 stat
TM54F_SL Can be changed: - Calculated: - Access level: 3
Data type: Unsigned32 Dynamic index: - Func. diagram: 2848
P-Group: Safety Integrated Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - -
Bit field: Bit Signal name 1 signal 0 signal FP
00 DI 20 High Low 2853
01 DI 21 High Low 2853
02 DI 22 High Low 2853
03 DI 23 High Low 2853
r10054 SI TM54F failsafe events active / SI failsafe event
TM54F_MA,
TM54F_SL
Can be changed: - Calculated: - Access level: 3
Data type: Unsigned32 Dynamic index: - Func. diagram: -
P-Group: Safety Integrated Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - -
Bit field: Bit Signal name 1 signal 0 signal FP
00 Commissioning mode active (p0010 = 95) Yes No -
01 Checksum error of the safety parameters Yes No -
02 Internal synchronization problem within
RM54F
Yes No -
03 Internal software error Yes No -
04 Overvoltage in the TM54F Yes No -
05 Undervoltage in the TM54F Yes No -
06 Error at test stop Yes No -
07 Error for data cross-check within TM54F Yes No -
08 Overvoltage in the TM54F Yes No -