Siemens SINAMICS S Series - r2064[0...7] PROFIdrive diagnostics clock synchronous mode; PD diag clock sync

Parameters
List of parameters
1-548
© Siemens AG 2007 All Rights Reserved
SINAMICS S List Manual (LH1), 07/2007
[26] = PZD 27 + 28
[27] = PZD 28 + 29
[28] = PZD 29 + 30
[29] = PZD 30 + 31
[30] = PZD 31 + 32
Note: IF1: Interface 1
Description: Displays the last parameter received from the PROFIBUS/PROFINET master for clock synchronism.
The parameters for clock synchronism are created when configuring the bus and are transferred at the start of
cyclic operation from the master to the slave.
Index: [0] = Clock synchronous mode activated
[1] = Bus cycle time (Tdp) [µs]
[2] = Master cycle time (Tmapc) [µs]
[3] = Instant of actual value acquisition (Ti) [µs]
[4] = Instant of setpoint acquisition (To) [µs]
[5] = Data exchange interval (Tdx) [µs]
[6] = PLL window (Tpll-w) [1/12 µs]
[7] = PLL delay time (Tpll-d) [1/12 µs]
Bit field: Bit Signal name 1 signal 0 signal FP
00 Bit 0 On Off -
01 Bit 1 On Off -
02 Bit 2 On Off -
03 Bit 3 On Off -
04 Bit 4 On Off -
05 Bit 5 On Off -
06 Bit 6 On Off -
07 Bit 7 On Off -
08 Bit 8 On Off -
09 Bit 9 On Off -
10 Bit 10 On Off -
11 Bit 11 On Off -
12 Bit 12 On Off -
13 Bit 13 On Off -
14 Bit 14 On Off -
15 Bit 15 On Off -
16 Bit 16 On Off -
17 Bit 17 On Off -
18 Bit 18 On Off -
19 Bit 19 On Off -
20 Bit 20 On Off -
21 Bit 21 On Off -
22 Bit 22 On Off -
23 Bit 23 On Off -
24 Bit 24 On Off -
25 Bit 25 On Off -
26 Bit 26 On Off -
27 Bit 27 On Off -
28 Bit 28 On Off -
29 Bit 29 On Off -
30 Bit 30 On Off -
31 Bit 31 On Off -
r2064[0...7] PROFIdrive diagnostics clock synchronous mode / PD diag clock sync
CU_CX32, CU_S Can be changed: - Calculated: - Access level: 3
Data type: Integer32 Dynamic index: - Func. diagram: 2410
P-Group: Communications Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - -