Siemens SINAMICS S Series - Figure 2-210 8018 - Separately excited synchronous motor (FEM, p0300 = 5)

Function Diagrams Signals and monitoring functions 2-1332
© Siemens AG 2007 All Rights Reserved
SINAMICS S List Manual (LH1), 07/2007
Figure 2-210 8018 – Separately excited synchronous motor (FEM, p0300 = 5)
- 8018 -
Function diagram
87654321
fp_8018_01_eng.vsd
DO: VECTOR
SINAMICS S
04.07.07 V02.05.00
Signals and montoring functions - Separately excited synchronous motor (FEM, p0300 = 5)
F07913
"Excitation current outside tolerance"
<1> Only for r1649.2 = 1 (excitation in operation, feedback signal)
<2> Only for vector control (p1300 >= 21) and after magnetization has been completed for a flying restart (r0056.4 = 1).
p0115[3] (4000.00 µs)
<1>
T0
<2>
F07914
"Flux outside tolerance"
0T
0T
0
1
0
1
0
1
0.01...10 000.00 [Arms]
p3208[D] (1.00)
0.00...10.00 [s]
p3209[D] (0.02)
0.1...50.0 [%]
p3205[D] (10.0)
r0068[0]
I_act abs. value
[6714.5]
0.01...10 000.00 [Arms]
p3207[D] (1.00)
0.1...100.0 [%]
p3204[D] (10.0)
0.0...10.0 [s]
p3203[D] (1.0)
0.1...100.0 [%]
p3201[D] (10.0)
0.1...100.0 [%]
p3202[D] (10.0)
0.0...10.0 [s]
p3206[D] (5.0)
r0084[0]
Flux actual value
r1598
Flux setpoint total
[6732.1]
[6725.8]
r1626
I_exc_set
[6727.8]
–
+
+
–
[8010.4]
|n_act| < p2161
r2199.0
I_exc_act
[6727.6]
r1641
Zero current
r2199.6
T0
T0
0
1
[2526.6]
[6732.3]
Frequency limit active
r0056.11
Motor stalled
r1408.12
Motor stalled
r2198.7
Motor stalled
r2198.7
[2536.3]
0.000..10.000 [s]
p2178[D] (0.010)
F07902
motor stalled (fault value 2)
F07902
motor stalled (fault value 3)
2 x r0384[M]
[2536.3]
Tsample