List of parameters
Parameters
1-789
© Siemens AG 2007 All Rights Reserved
SINAMICS S List Manual (LH1), 07/2007
Note: Inversion using p4048 has been taken into account.
DO: Digital Output
Description: Displays the status of the digital outputs of terminal module 31 (TM31).
Note: Inversion using p4048 has been taken into account.
The setting of the DI/DO as either input or output is of no significance (p4028).
DO: Digital Output
DI/DO: Bidirectional Digital Input/Output
Description: Displays the status of the digital outputs of terminal module 41 (TM41).
Note: Inversion using p4048 has been taken into account.
The setting of the DI/DO as either input or output is of no significance (p4028).
DO: Digital Output
DI/DO: Bidirectional Digital Input/Output
Description: Displays the status of the digital outputs of terminal module 15 (TM15).
r4047 TM31 digital outputs status / TM31 DO status
TM31 Can be changed: - Calculated: - Access level: 1
Data type: Unsigned32 Dynamic index: - Func. diagram: 9556, 9560,
9562
P-Group: Commands Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - -
Bit field: Bit Signal name 1 signal 0 signal FP
00 DO 0 (X542.1 - 3) High Low -
01 DO 1 (X542.4 - 6) High Low -
08 DI/DO 8 (X541.2) High Low -
09 DI/DO 9 (X541.3) High Low -
10 DI/DO 10 (X541.4) High Low -
11 DI/DO 11 (X541.5) High Low -
r4047 TM41 digital outputs status / TM41 DO status
TM41 Can be changed: - Calculated: - Access level: 1
Data type: Unsigned32 Dynamic index: - Func. diagram: -
P-Group: Commands Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - -
Bit field: Bit Signal name 1 signal 0 signal FP
08 DI/DO 0 (X521.1) High Low 9661
09 DI/DO 1 (X521.2) High Low 9661
10 DI/DO 2 (X521.3) High Low 9662
11 DI/DO 3 (X521.4) High Low 9662
r4047 TM15DI/DO digital outputs, status / TM15D DO status
TM15DI_DO Can be changed: - Calculated: - Access level: 1
Data type: Unsigned32 Dynamic index: - Func. diagram: 9400, 9401,
9402
P-Group: Commands Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - -
To Next Page
Loading...
