Siemens SINAMICS S Series - p9502 SI motion axis type (Control Unit); SI Mtn axis type; p9503 SI motion SCA (SN) enable (Control Unit); SI Mtn SCA enab

List of parameters
Parameters
1-995
© Siemens AG 2007 All Rights Reserved
SINAMICS S List Manual (LH1), 07/2007
Description: Sets the axis type (linear axis or rotary axis/spindle).
Values: 0: Linear axis
1: Rot axis/spindle
Note: For the commissioning software, after changing over the axis type, the units dependent on the axis type are only
updated after a project upload.
A change only becomes effective after a POWER ON.
Description: Setting to enable the function "Safe Cam" (SCA).
Dependency: Refer to: p9501
Refer to: F01686
p9502 SI motion axis type (Control Unit) / SI Mtn axis type
SERVO, VECTOR Can be changed: C2 Calculated: - Access level: 3
Data type: Integer16 Dynamic index: - Func. diagram: -
P-Group: Safety Integrated Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
0 1 0
p9503 SI motion SCA (SN) enable (Control Unit) / SI Mtn SCA enab
SERVO, VECTOR Can be changed: U, T Calculated: - Access level: 4
Data type: Unsigned32 Dynamic index: - Func. diagram: -
P-Group: Safety Integrated Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - 0000 bin
Bit field: Bit Signal name 1 signal 0 signal FP
00 Enable SCA1 (SN1) Enable Inhibit -
01 Enable SCA2 (SN2) Enable Inhibit -
02 Enable SCA3 (SN3) Enable Inhibit -
03 Enable SCA4 (SN4) Enable Inhibit -
04 Enable SCA5 (SN5) Enable Inhibit -
05 Enable SCA6 (SN6) Enable Inhibit -
06 Enable SCA7 (SN7) Enable Inhibit -
07 Enable SCA8 (SN8) Enable Inhibit -
08 Enable SCA9 (SN9) Enable Inhibit -
09 Enable SCA10 (SN10) Enable Inhibit -
10 Enable SCA11 (SN11) Enable Inhibit -
11 Enable SCA12 (SN12) Enable Inhibit -
12 Enable SCA13 (SN13) Enable Inhibit -
13 Enable SCA14 (SN14) Enable Inhibit -
14 Enable SCA15 (SN15) Enable Inhibit -
15 Enable SCA16 (SN16) Enable Inhibit -
16 Enable SCA17 (SN17) Enable Inhibit -
17 Enable SCA18 (SN18) Enable Inhibit -
18 Enable SCA19 (SN19) Enable Inhibit -
19 Enable SCA20 (SN20) Enable Inhibit -
20 Enable SCA21 (SN21) Enable Inhibit -
21 Enable SCA22 (SN22) Enable Inhibit -
22 Enable SCA23 (SN23) Enable Inhibit -
23 Enable SCA24 (SN24) Enable Inhibit -
24 Enable SCA25 (SN25) Enable Inhibit -
25 Enable SCA26 (SN26) Enable Inhibit -
26 Enable SCA27 (SN27) Enable Inhibit -
27 Enable SCA28 (SN28) Enable Inhibit -
28 Enable SCA29 (SN29) Enable Inhibit -
29 Enable SCA30 (SN30) Enable Inhibit -