Siemens SINAMICS S Series User Manual

Parameters
List of parameters
1-478
© Siemens AG 2007 All Rights Reserved
SINAMICS S List Manual (LH1), 07/2007
Description: Displays the effective proportional gain of the controller for the speed adaptation.
Description: Sets the integral time of the controller for speed adaptation without encoder
Description: Displays the effective gain of the integral component of the controller for speed adaptation.
Description: Displays the P component of the controller for speed adaptation.
Description: Displays the I component of the controller for speed adaptation.
r1765 Motor model, speed adaptation Kp effective / MotM n_ada Kp act
VECTOR (n/M) Can be changed: - Calculated: - Access level: 4
Data type: Floating Point Dynamic index: - Func. diagram: -
P-Group: Closed-loop control Units group: - Unit selection: -
Not for motor type: REL, FEM Expert list: 1
Min Max Factory setting
- - -
p1767[0...n] Motor model without encoder speed adaptation Tn / MotMod woE n_adaTn
VECTOR (n/M) Can be changed: U, T Calculated: CALC_MOD_CON Access level: 3
Data type: Floating Point Dynamic index: DDS, p0180 Func. diagram: 6730
P-Group: Closed-loop control Units group: - Unit selection: -
Not for motor type: REL, FEM Expert list: 1
Min Max Factory setting
1 [ms] 200 [ms] 4 [ms]
r1768 Motor model, speed adaptation Vi effective / MotM n_ada Vi act
VECTOR (n/M) Can be changed: - Calculated: - Access level: 4
Data type: Floating Point Dynamic index: - Func. diagram: -
P-Group: Closed-loop control Units group: - Unit selection: -
Not for motor type: REL, FEM Expert list: 1
Min Max Factory setting
- - -
r1770 Motor model speed adaptation proportional component / MotMod n_adapt Kp
VECTOR (n/M) Can be changed: - Calculated: - Access level: 3
Data type: Floating Point Dynamic index: - Func. diagram: 6730
P-Group: Closed-loop control Units group: 3_1 Unit selection: p0505
Not for motor type: REL, FEM Expert list: 1
Min Max Factory setting
- [RPM] - [RPM] - [RPM]
r1771 Motor model speed adaptation I comp. / MotMod n_adapt Tn
VECTOR (n/M) Can be changed: - Calculated: - Access level: 3
Data type: Floating Point Dynamic index: - Func. diagram: 6730
P-Group: Closed-loop control Units group: 3_1 Unit selection: p0505
Not for motor type: REL, FEM Expert list: 1
Min Max Factory setting
- [RPM] - [RPM] - [RPM]

Siemens SINAMICS S Series Specifications

General

Brand	Siemens
Model	SINAMICS S Series
Category	Industrial Equipment
Language	English