Siemens SINAMICS S Series - r3777[0...1] CO: APC filter branch 1 display values; APC branch 1 val; p3784[0...n] BI: Sync-line-drive external increase voltage; Sync ext V incr; p3785[0...n] BI: Sync-line-drive external decrease voltage; Sync ext V decr; p3800[0...n] Sync-line-drive activation; Sync act

List of parameters
Parameters
1-743
© Siemens AG 2007 All Rights Reserved
SINAMICS S List Manual (LH1), 07/2007
Description: Displays the velocities in filter branch 1.
Index: [0] = Filter 1.1 input value
[1] = Filter 1.1 output value
Description: Sets the signal source to increase the voltage for external line-drive synchronization.
BI: p3784 = 1 signal:
The voltage is increased.
Note: Only SINAMICS GM150.
Description: Sets the signal source to decrease the voltage for external line-drive synchronization.
BI: p3785 = 1 signal:
The voltage is lowered.
Note: Only SINAMICS GM150.
Description: Sets the activation for the line-drive synchronization.
Values: 0: Sync-line-drive de-activated
1: Sync-line-drive activated VSM-INT
Dependency: Refer to: p3801, p3802
Note: When the ground fault monitoring initiates a fault for overlapping synchronizing the threshold value p0287[1] for the
Motor Module and the associated infeed must be appropriately increased (e.g. p0287[1] = 100 %).
For p3800 = 1, the following applies:
r3777[0...1] CO: APC filter branch 1 display values / APC branch 1 val
SERVO (APC, Lin) Can be changed: - Calculated: - Access level: 3
Data type: Floating Point Dynamic index: - Func. diagram: 7012
P-Group: Setpoints Units group: 4_1 Unit selection: p0505
Not for motor type: - Expert list: 1
Min Max Factory setting
- [m/min] - [m/min] - [m/min]
p3784[0...n] BI: Sync-line-drive external increase voltage / Sync ext V incr
VECTOR Can be changed: T Calculated: - Access level: 2
Data type: Unsigned32 / Binary Dynamic index: CDS, p0170 Func. diagram: -
P-Group: Functions Units group: - Unit selection: -
Not for motor type: - Expert list: 0
Min Max Factory setting
- - 0
p3785[0...n] BI: Sync-line-drive external decrease voltage / Sync ext V decr
VECTOR Can be changed: T Calculated: - Access level: 2
Data type: Unsigned32 / Binary Dynamic index: CDS, p0170 Func. diagram: -
P-Group: Functions Units group: - Unit selection: -
Not for motor type: - Expert list: 0
Min Max Factory setting
- - 0
p3800[0...n] Sync-line-drive activation / Sync act
VECTOR Can be changed: T Calculated: - Access level: 2
Data type: Integer16 Dynamic index: DDS, p0180 Func. diagram: 7020
P-Group: Functions Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
0 1 0