Siemens SINAMICS S Series - p4069[0...1] BI: TM31 analog inputs, signal source for enable; TM31 AI enable; p4069[0...0] BI: TM41 analog input, signal source for enable; TM41 AI enable; p4071[0...1] CI: TB30 analog outputs, signal source; TB30 AO sig_source; p4071[0...1] CI: TM31 analog outputs, signal source; TM31 AO sig_source

List of parameters
Parameters
1-805
© Siemens AG 2007 All Rights Reserved
SINAMICS S List Manual (LH1), 07/2007
Description: Sets the signal source for the enable signal of the analog inputs of terminal module 31 (TM31).
Index: [0] = AI 0 (X521.1/X521.2, S5.0)
[1] = AI 1 (X521.3/X521.4, S5.1)
Description: Sets the signal source for the enable signal of the analog input of terminal module 41 (TM41).
Index: [0] = AI 0 (X523.1/X523.2)
Description: Sets the signal source for the analog outputs of the Terminal Board 30 (TB30).
Index: [0] = AO 0 (X482.5/X482.6)
[1] = AO 1 (X482.7/X482.8)
Note: AO: Analog Output
Description: Sets the signal source for the analog outputs of terminal module 31 (TM31).
Index: [0] = AO 0 (X522.1, X522.2, X522.3)
[1] = AO 1 (X522.4, X522.5, X522.6)
Note: AO: Analog Output
p4069[0...1] BI: TM31 analog inputs, signal source for enable / TM31 AI enable
TM31 Can be changed: U, T Calculated: - Access level: 3
Data type: Unsigned32 / Binary Dynamic index: - Func. diagram: 9566, 9568
P-Group: Terminals Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - 1
p4069[0...0] BI: TM41 analog input, signal source for enable / TM41 AI enable
TM41 Can be changed: U, T Calculated: - Access level: 3
Data type: Unsigned32 / Binary Dynamic index: - Func. diagram: 9663
P-Group: Terminals Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - 1
p4071[0...1] CI: TB30 analog outputs, signal source / TB30 AO sig_source
TB30 Can be changed: U, T Calculated: - Access level: 1
Data type: Unsigned32 / FloatingPoint32 Dynamic index: - Func. diagram: 1790, 9106
P-Group: Terminals Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - 0
p4071[0...1] CI: TM31 analog outputs, signal source / TM31 AO sig_source
TM31 Can be changed: U, T Calculated: - Access level: 1
Data type: Unsigned32 / FloatingPoint32 Dynamic index: - Func. diagram: 1840, 9572
P-Group: Terminals Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - 0