Siemens SINAMICS S Series - p4036 BI: TM15 DI;DO signal source for terminal DI;DO 6; TM15 D S_srcDI;DO 6; p4037 BI: TM15 DI;DO signal source for terminal DI;DO 7; TM15 D S_srcDI;DO 7; p4038 BI: TM31 signal source for terminal DI;DO 8; TM31 S_src DI;DO 8; p4038 BI: TM41 signal source for terminal DI;DO 0; TM41 S_src DI;DO 0

Parameters
List of parameters
1-784
© Siemens AG 2007 All Rights Reserved
SINAMICS S List Manual (LH1), 07/2007
Description: Sets the signal source for terminal DI/DO 6 (X520.8) of terminal module 15 (TM15).
Note: Prerequisite: The DI/DO must be set as an output (p4028.6 = 1).
DI/DO: Bidirectional Digital Input/Output
Description: Sets the signal source for terminal DI/DO 7 (X520.9) of terminal module 15 (TM15).
Note: Prerequisite: The DI/DO must be set as an output (p4028.7 = 1).
DI/DO: Bidirectional Digital Input/Output
Description: Sets the signal source for terminal DI/DO 8 (X541.2) of terminal module 31 (TM31).
Note: Prerequisite: The DI/DO must be set as an output (p4028.8 = 1).
DI/DO: Bidirectional Digital Input/Output
Description: Sets the signal source for terminal DI/DO 0 (X521.1) of terminal module 41 (TM41).
Note: Prerequisite: The DI/DO must be set as an output (p4028.8 = 1).
DI/DO: Bidirectional Digital Input/Output
p4036 BI: TM15DI/DO signal source for terminal DI/DO 6 / TM15D S_srcDI/DO 6
TM15DI_DO Can be changed: U, T Calculated: - Access level: 1
Data type: Unsigned32 / Binary Dynamic index: - Func. diagram: 9400
P-Group: Commands Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - 0
p4037 BI: TM15DI/DO signal source for terminal DI/DO 7 / TM15D S_srcDI/DO 7
TM15DI_DO Can be changed: U, T Calculated: - Access level: 1
Data type: Unsigned32 / Binary Dynamic index: - Func. diagram: 9400
P-Group: Commands Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - 0
p4038 BI: TM31 signal source for terminal DI/DO 8 / TM31 S_src DI/DO 8
TM31 Can be changed: U, T Calculated: - Access level: 1
Data type: Unsigned32 / Binary Dynamic index: - Func. diagram: 1840, 9560
P-Group: Commands Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - 0
p4038 BI: TM41 signal source for terminal DI/DO 0 / TM41 S_src DI/DO 0
TM41 Can be changed: U, T Calculated: - Access level: 1
Data type: Unsigned32 / Binary Dynamic index: - Func. diagram: 9661
P-Group: Commands Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - 0