Siemens SINAMICS S Series - r8850[0...15] CO: IF2 PZD receive word; IF2 PZD recv word; p8851[0...7] CI: IF2 PZD send word; IF2 PZD send word

List of parameters
Parameters
1-959
© Siemens AG 2007 All Rights Reserved
SINAMICS S List Manual (LH1), 07/2007
Index: [0] = PZD 1
[1] = PZD 2
[2] = PZD 3
[3] = PZD 4
[4] = PZD 5
Note: PZD1 to PZD2 are displayed bit-serially in r8890 to r8891.
Description: Connector output for interconnecting the PZD (setpoints) received via interface 2 in the word format.
Index: [0] = PZD 1
[1] = PZD 2
[2] = PZD 3
[3] = PZD 4
[4] = PZD 5
[5] = PZD 6
[6] = PZD 7
[7] = PZD 8
[8] = PZD 9
[9] = PZD 10
[10] = PZD 11
[11] = PZD 12
[12] = PZD 13
[13] = PZD 14
[14] = PZD 15
[15] = PZD 16
Dependency: Refer to: r8860, r8890, r8891, r8892, r8893
Note: IF2: Interface 2
PZD1 to PZD4 are displayed bit-serially in r8890 to r8893.
Description: Selects the PZD (actual values) to be sent via interface 2 in the word format.
Index: [0] = PZD 1
[1] = PZD 2
[2] = PZD 3
[3] = PZD 4
[4] = PZD 5
[5] = PZD 6
[6] = PZD 7
[7] = PZD 8
Note: IF2: Interface 2
r8850[0...15] CO: IF2 PZD receive word / IF2 PZD recv word
SERVO, VECTOR Can be changed: - Calculated: - Access level: 3
Data type: Integer16 Dynamic index: - Func. diagram: 2485, 9204,
9206
P-Group: Communications Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - -
p8851[0...7] CI: IF2 PZD send word / IF2 PZD send word
A_INF, B_INF,
S_INF
Can be changed: U, T Calculated: - Access level: 3
Data type: Unsigned32 / Integer16 Dynamic index: - Func. diagram: 2493, 9210
P-Group: Communications Units group: - Unit selection: -
Not for motor type: - Expert list: 1
Min Max Factory setting
- - 0