Siemens SINAMICS S Series - p4095 TB30 digital inputs, simulation mode; TB30 DI sim_mode; p4095 TM31 digital inputs, simulation mode; TM31 DI sim

To Next Page

To Previous Page

List of parameters

Parameters

1-815

SINAMICS S List Manual (LH1), 07/2007

Description: Sets the simulation mode for the digital inputs of the Terminal Board 30 (TB30).

Dependency: The setpoint for the input signals is specified using p4096.

Refer to: p4096

Note: This parameter is not saved when data is backed-up (p0971, p0977).

DI: Digital input

Description: Sets the simulation mode for the digital inputs of terminal module 31 (TM31).

Dependency: The setpoint for the input signals is specified using p4096.

Refer to: p4096

Note: This parameter is not saved when data is backed-up (p0971, p0977).

DI: Digital input

DI/DO: Bidirectional Digital Input/Output

p4095 TB30 digital inputs, simulation mode / TB30 DI sim_mode

TB30 Can be changed: U, T Calculated: - Access level: 2

Data type: Unsigned32 Dynamic index: - Func. diagram: 1790, 9100

P-Group: Commands Units group: - Unit selection: -

Not for motor type: - Expert list: 1

Min Max Factory setting

- - 0000 bin

Bit field: Bit Signal name 1 signal 0 signal FP

00 DI 0 (X481.1) Simulation Terminal eval. -

01 DI 1 (X481.2) Simulation Terminal eval. -

02 DI 2 (X481.3) Simulation Terminal eval. -

03 DI 3 (X481.4) Simulation Terminal eval. -

p4095 TM31 digital inputs, simulation mode / TM31 DI sim_mode

TM31 Can be changed: U, T Calculated: - Access level: 2

Data type: Unsigned32 Dynamic index: - Func. diagram: 1840, 9550,

9552, 9560, 9562

P-Group: Terminals Units group: - Unit selection: -

Not for motor type: - Expert list: 1

Min Max Factory setting

- - 0000 bin

Bit field: Bit Signal name 1 signal 0 signal FP

00 DI 0 (X520.1) Simulation Terminal eval. -

01 DI 1 (X520.2) Simulation Terminal eval. -

02 DI 2 (X520.3) Simulation Terminal eval. -

03 DI 3 (X520.4) Simulation Terminal eval. -

04 DI 4 (X530.1) Simulation Terminal eval. -

05 DI 5 (X530.2) Simulation Terminal eval. -

06 DI 6 (X530.3) Simulation Terminal eval. -

07 DI 7 (X530.4) Simulation Terminal eval. -

08 DI/DO 8 (X541.2) Simulation Terminal eval. -

09 DI/DO 9 (X541.3) Simulation Terminal eval. -

10 DI/DO 10 (X541.4) Simulation Terminal eval. -

11 DI/DO 11 (X541.5) Simulation Terminal eval. -

Main Page

Siemens SINAMICS S Series - p4095 TB30 digital inputs, simulation mode; TB30 DI sim_mode; p4095 TM31 digital inputs, simulation mode; TM31 DI sim_mode

Table of Contents

Related product manuals