Siemens SINAMICS S Series - p4786[0...1] Trace physical address signal 6; Trace PhyAddr Sig6; p4787[0...1] Trace physical address signal 7; Trace PhyAddr Sig7; p4789[0...1] Trace physical address trigger signal; Trace PhyAddr Trig; r4790[0...1] Trace, data type 5 traced; Trace rec type 5

Parameters
List of parameters
1-876
© Siemens AG 2007 All Rights Reserved
SINAMICS S List Manual (LH1), 07/2007
Index: [0] = Trace 0
[1] = Trace 1
Description: Sets the physical address for the seventh signal to be traced.
The data type is defined using p4736.
The parameter can only be written to if the number of trace channels (p4702) is eight.
Index: [0] = Trace 0
[1] = Trace 1
Description: Sets the physical address for the eighth signal to be traced.
The data type is defined using p4737.
The parameter can only be written to if the number of trace channels (p4702) is eight.
Index: [0] = Trace 0
[1] = Trace 1
Description: Sets the physical address for the trigger signal.
The data type is defined by making the appropriate selection in p4711.
Index: [0] = Trace 0
[1] = Trace 1
Index: [0] = Trace 0
[1] = Trace 1
p4786[0...1] Trace physical address signal 6 / Trace PhyAddr Sig6
CU_CX32, CU_S Can be changed: U, T Calculated: - Access level: 3
Data type: Unsigned32 Dynamic index: - Func. diagram: -
P-Group: Trace and function generator Units group: - Unit selection: -
Not for motor type: - Expert list: 0
Min Max Factory setting
0000 bin 1111 1111 1111 1111 1111 1111
1111 1111 bin
0000 bin
p4787[0...1] Trace physical address signal 7 / Trace PhyAddr Sig7
CU_CX32, CU_S Can be changed: U, T Calculated: - Access level: 3
Data type: Unsigned32 Dynamic index: - Func. diagram: -
P-Group: Trace and function generator Units group: - Unit selection: -
Not for motor type: - Expert list: 0
Min Max Factory setting
0000 bin 1111 1111 1111 1111 1111 1111
1111 1111 bin
0000 bin
p4789[0...1] Trace physical address trigger signal / Trace PhyAddr Trig
CU_CX32, CU_S Can be changed: U, T Calculated: - Access level: 3
Data type: Unsigned32 Dynamic index: - Func. diagram: -
P-Group: Trace and function generator Units group: - Unit selection: -
Not for motor type: - Expert list: 0
Min Max Factory setting
0000 hex FFFF FFFF hex 0000 hex
r4790[0...1] Trace, data type 5 traced / Trace rec type 5
CU_CX32, CU_S Can be changed: - Calculated: - Access level: 3
Data type: Unsigned32 Dynamic index: - Func. diagram: -
P-Group: Trace and function generator Units group: - Unit selection: -
Not for motor type: - Expert list: 0
Min Max Factory setting
- - -